0
What else can I help you with?
How do you remove the cover box to get to the fuel injector in Envoy 2002?
To remove the cover box to get to the fuel injector on the 2002 Envoy, first remove the intake manifold and the valve cover. You can do this by loosening the four bolts that hold the intake manifold first.Ê
How do you remove the pass side manifold on a 2002 Ford F-150 4.6l v8?
I have a 2002 ford F150 4.6L V8 and would like to know how to remove the passenger side manifold?
How many hours does it take to replace the manifold on a 2002 oldsmobile bravada?
Replacing the manifold on a 2002 Oldsmobile Bravada typically takes around 6 to 8 hours, depending on the mechanic's experience and the specific conditions of the vehicle. Factors such as rust, accessibility, and the need for additional repairs can also influence the time required. It's advisable to consult a professional for a more accurate estimate based on the specific situation.
Where is 2002 Mitsubishi Lancer's fuel injector location?
Fuel injectors are located on the 2002 Mitsubishi Lancer's fuel rail. The fuel rail is located behind the engine on top the of intake manifold plenum.
Where is the camshaff sensor located on a 2002?
2002 bravada oldsmobile
How do you replace a coil pack on a 2002 bravada?
To replace a coil pack on a 2002 Bravada, first disconnect the negative battery terminal to ensure safety. Then, locate the coil pack, typically found near the engine's intake manifold, and remove the electrical connector and the mounting bolts. Take out the old coil pack and install the new one by reversing the steps, ensuring a secure connection. Finally, reconnect the battery and start the engine to test the new coil pack.
Show the location of camshaft position sensor for 2002 Oldsmobile bravada?
show location of camshaft position sensor for 2002 Oldsmobile bravada.
Where is fuel pressure regulator on 2002 GMC Sanoma V6?
It is located under the upper intake manifold, attached to the bank of fuel injector poppets also known as the "spider". The upper intake manifold must be removed to gain access.
How many quarts of oil does a 2002 Oldsmobile Bravada take?
I have a 2002 Oldsmobile bravada and we changed the oil today it took about 7-8 quarts.
What does a PCV valve look like in a 2002 cavalier?
It doesn't actually have a separate PCV valve. It is an orifice type that is in the intake manifold and is a pain to get to. You have to remove the manifold by removing the nuts(13mm) that hold the manifold to the block, then remove the top studs(6mm). You should be able to pull it out and see the orifice once your remove the throttle body from the intake manifold. Don't forget to remove the little bracket on the bottom side of the manifold that connects it to the block.
2002 olds bravada misfire?
It could be tune up related, fuel filter, air filter, spark plugs, ignition wires, distributor cap and rotor. It could also be a bad fuel injector(s).
How do you get the struts off the front of your 2002 Bravada?
To remove the struts from the front of a 2002 Bravada, first, safely lift and support the vehicle on jack stands. Remove the wheel and brake components to access the strut assembly. Disconnect the strut from the steering knuckle using a socket wrench, and then remove the upper strut mounting bolts located in the engine bay. Finally, pull the strut assembly out from its mount and repeat for the opposite side.
