Chase your ingnition wires into head light and unplug them.
insert key into ignition and turn to accessory and get a pin and depress it into the hole by the key and pull the switch out and then you can unscrew the big nut off the switch.
is key code located on ignition switch of 97 honda civic
The entire ignition switch assembly will unholy from the steering column. The key is required to remove the cylinder from the switch.
i have a 06 Chevy cobalt and can't get the key out of the ignition switch
if you go to www.impalahq.com and find where you take the dash off this will get you in the right direction. i know you have to remove the dash to remove the key switch.
how to remove key stuck in ignition switch in Chevy colbalt
Place the key on the ignition switch to the On (II) position. Then, press the Select/Reset button while the key is in this position. Keep the button pressed until the engine light disappears.
Open the covers behind the steeering wheel. There will be 6 screws and some snap-ins. Look for the ignition switch on the left side. It should be behing the key cylinder. Remove the 3 screws holding the switch. You should be able to pull the switch out.
for key switch replacementare you changing the key switch or the electric switch that attaches to the key switch key switch- take off columb cover remove ing electric switch then with 1/4 inch drill bit drill out top of studs then remove assembly and replace screw studs with new screws and switch cost, when i did mine was $160.00 good luck with project.
Check the park/neutral safety switch, or clutch switch if its a manual.
wiggle the KEY and jiggle the handlebars at the same time.
With no key you will have to drill out the existing tumbler assembly from the switch in order to unscrew the ignition switch bezel.