answersLogoWhite

0

try super glue or go to a auto wrecker

User Avatar

Wiki User

14y ago

What else can I help you with?

Related Questions

Where is the fuse for the ac blower motor on the 2010 prostar?

Fuses and relays are under the dash.. there's a panel you remove on the passenger side (where a glove compartment would typically be on a truck which had one), and the panel is right there.. there'll be a plastic sheet which you remove to expose the fuses and relays, and that has a diagram on it.


How do you you remove door panles from a 2010 VW fox?

how to remove door panel vw fox


How do you Remove door panel 2010 Explorer?

How do I install passenger side mirror 2010 Ford Explorer


How do you remove right side panel on a 2010 Ultra Classic Trike?

You unscrew it.


How do you remove door panel 2010 ford explorer?

How do I install passenger side mirror 2010 Ford Explorer


What are the release dates for Hatch - 2010?

Hatch - 2010 was released on: USA: April 2010


How do you remove the front dash speaker on a 2010 Chevy Tahoe?

You will need to remove the screws in the door pull area, remove the power window panel, and the door lock pull, from there you carefully pop the plastic retainers holding the inner door panel to the door, work your way around carefully prying them away. The speaker will be bolted to the steel door behind the grille that is a part of the door panel, unbolt it and replace with the same size new speaker.


How do you remove driver door panel on a 2010 ford F 150?

remove interior door panle diver sidef-150


Where is the fuse box in 2010 mustang?

According to the owners manual , the fuse panel is in the passenger area , behind the kick panel . You open a trim panel door and then remove a cover panel to access the fuses


Where is the cabin air filter 2010 Cadillac SRX?

2010 Cadillac SRX cabin air filter is located behind the glove box. Must remove 2 side trim panels on passenger side of middle console. Then remove panel under glove box covering blower. 3 plastic rivets. Then remove glove box 9 screws. 4 on bottom door, 3 inside box on top and 2 left side, (the 2 were hidden by trim panel) Drop down glove box and you will see rectangle access panel for filter above blower. Panel has clip on each end and on top. Pull filter and place new filter with arrow in proper direction and then reassemble. 45 minutes to do job. Getting trim panel back in is a PIA because of passenger seat and how clips are on panels. Good Luck


How do you upgrade office 2002 to office 2010?

Purchase an Office 2010 licence and DVDUninstall the Office 2002 through the Control Panel > Add or remove programsInstall Office 2012


Where is the oil filter on a 2010 corolla?

under the engine in the front. you have to lift the car AND then remove the plastic guard in order to see the oil filter.