To replace the radiator in a 2008 VE Commodore V8, start by draining the coolant from the radiator using the drain plug. Remove the front grille and any necessary components blocking access to the radiator, such as the fans and hoses. Detach the upper and lower radiator hoses, then unbolt and remove the radiator from its mounts. Install the new radiator by reversing the removal process, ensuring all connections are secure and refill the cooling system with the appropriate coolant.
yes
Normally the V8 radiator is larger
A Holden Commodore V8 has a 4D Sedan body type. It has an engine size of 3.0L and uses V6 cylinders. Its dimensions are: 1476mm x 4894mm x 1899mm. This car uses unleaded petrol.
There are 3 different engines available to the VS Commodore. First is a 3.8L ECOTEC V6. The second is a 5L V8 and the third is a 5.7L V8 (an enlarged version of the 5L ) only available to the "SENATOR" version of the VS.
Holden's Factory in Elizabeth, South Australia. The V8 used in the SS is built in Canada or Mexico.
if ur in an emission control state that truck is OBD on board diagnostic an will not pass inspection if u make the change if not u will need ecm motor mounts. tranny rear end radiator will depend on how big a v8 u go with
Yes, but you'll need V8 motor mounts and exhaust. Probably should have a bigger radiator also.
The 2008 Aston-Martin V8-Vantage has a V8 engine.
Most of these do not have one.You must remove the lower radiator hose to drain the radiator.
The 2008 Wrangler did not have an option for a V8 from the factory.
There are 3 drain plugs on the Toyota Tundra V8 engine and radiator. On the radiator petcock, the plastic thumbscrew, and drain valves are on the bottom, driverâ??s side of the radiator.
It's a stupid little plastic plug that can be stripped very easily. Take it to a rad shop and have them replace it.