To replace the gas pedal in a 1998 GMC or Chevy van, start by disconnecting the negative battery cable to ensure safety. Remove the trim panel covering the pedal assembly, then unbolt the gas pedal from its mounting bracket. Disconnect the throttle cable or electronic connector, depending on the model, and install the new gas pedal by reversing the removal steps. Finally, reconnect the battery and test the pedal for proper function.
Diode or module??? the module is under the dash straight back from the gas pedal..
how to remove a clutch pedal assembly 2004 gmc sierra
Yes thay are the same if both of them are 1/2 tons are 3/4 tons. Chevy and GMC is the samething.
there is chevrolet silverado and gmc sierra as far as i know they don't make any chevy sierra's.
1) turn key just to the ON position (not start) 2)fully depress the gas pedal 3 times 3) take your foot off the gas pedal and turn the key to start
The 1998 GMC signal flasher relay switch will be behind the drivers side dashboard. The signal flasher relay switch will be on the left-hand side of the gas pedal.
Chevy and GMC are essentially two branches of the same company. The GMC name is a subsidary of Chevrolet. Because Chevy is owned by GMC.
Chevy and GMC are both part of the General Motors corperation
It should be 25 gallons US, the same as a GMC Safari.
GMC Sierra
What year.For my 1997 it is located on the metal bracket right above the gas pedal and it a small black looking box.
depends on what year my 2000 gmc sierra fule pump is in the gas tank, about 180.00 just for the pump.