0
Mark drive shaft and yoke to be sure to install in the same position to maintain factory balance Remove and discard 2 small "u" bolts at rear end
Pry driveshaft out of yoke
Slide driveshaft off splines at transmission tail piece
Bring driveshaft to an auto parts/machine shop to have new "U" joint pressed into driveshaft
Replace "U" Bolts with new ones
What else can I help you with?
How do you replace a CV joint on a 1992 Chevy pickup?
how do you replace a CV joint on a 1992 Chevy pickup?
How do you replace a universal-joint on 1997 pickup 2-wheel drive?
with a u-joint press or c-clamp, there is a procedure, consult a repair manual, probably at your local library.
What is the cost of replacing a universal joint on a Dodge pickup 2500?
The cost to replace a universal joint on a 2500 Dodge truck will vary depending on if you replace it yourself or take it to a shop. The cost for the part can vary depending on location and can cost from about $12.00 to $20.00. At a shop, the cost will include the part plus labor.
How much is a universal joint for a 1988 Chevy siverodeo?
About $ 12.00
How do you replace a Honda CR-V drive shaft universal joint?
drive universal jount
How to remove a lower ball joint on a 1995 Chevy s-10?
Remove the tire and wheel from your 1995 Chevy S 10 pickup truck. Remove the ball joint retaining nut. Pound the ball joint out with a hammer.
How much does labor cost changing universal joint on a Chevy silverado?
$40.00 to $50.00 labor
What could cause a clunk in a 2000 GMC pickup when shifting into drive?
Loose universal joint(s) in drive train.
What causes a bad vibration on accelerating on a rear wheel drive pickup truck?
Could be a universal joint gone bad.
Can you replace a universal joint in a 2003 Honda CR-V or do you have to replace the whole drive shaft?
You have to replace the whole drive shaft.
I believe these are just pressed in from the factory. It has a piece of plastic sticking out of the end of the yoke eye. How do you replace a universal joint on a Chevy S 10 truck?
I heat the yoke eye and joint cap with a torch until the plastic oozes out then press the joint out as usual. The replacement joint will have regular retaining clips to hold the joint cap in place.
Replaced universal joint in Chevy s-10 truck and now have vibration?
Must not be installed correctly. If the joint is not perfectly centered it will vibrate.
