1. Remove ashtray. 2. Remove ashtray track assembly (two screws underneath). 3. Replace bulb. 4. Install ashtray track assembly. 5. Insert ashtray.
To replace the ashtray bulb in a 2007 Hyundai Santa Fe, start by removing the ashtray from its housing. Then, locate the bulb holder; twist it counterclockwise to remove it. Replace the old bulb with a new one, ensuring it is securely in place, and reassemble the ashtray back into its slot. Finally, test the new bulb to confirm it works properly.
To replace the front ashtray on a 2004 Infiniti G35, first, remove the center console trim by carefully prying it up with a trim tool or flathead screwdriver. Once the trim is removed, unscrew the ashtray assembly from its housing. After that, simply disconnect any electrical connectors if applicable, replace it with the new ashtray, and reassemble the console by reversing the steps. Make sure everything is securely in place before finishing.
* Remove the ashtray and ashtray holder * Remove the mounting screws lower the radio unplug the electrical connector and antenna lead then pull the radio out of dashboard
Take the old one out and put a new one in.
To remove the ashtray on a Toyota Avensis, first, ensure the vehicle is parked and the ignition is off. Gently pull the ashtray out of its slot; it may have a slight resistance due to clips. If necessary, press down on any release tab or lever located on the sides of the ashtray to ease its removal. Once it's free, you can clean or replace it as needed.
remove the whole console that goes around your radio and down to the ashtray. 2 screws up top and 2 down below. be carefull because the plastic is not to strong. but when you get it out you will see it at the bottom behind the ashtray... spiked2u@aol.com
To change the ashtray light bulb in a 1999 Volvo S70, first remove the ashtray from its compartment by pulling it out. Then, locate the small bulb holder at the bottom of the ashtray; twist it counterclockwise to remove it. Replace the old bulb with a new one of the same type, reinsert the bulb holder, and slide the ashtray back into its compartment. Ensure the new bulb is functioning by turning on the car's interior lights.
Don't be a fool like me and take the dash instrument cover off and break it. Just unscrew the screws in the ashtray and pull the base out. The bulb is beside the cigarette lighter, twist and pull out, replace bulb, push and twist back in.
there is no ashtray
Behind the Ashtray I just fixed mine last night. It turns out that it was attached by a clip on the right side of the ashtray frame inside the dashboard. I took out the removable "cup" part of the ashtray, then removed the two upper and two lower ashtray frame screws. Next, I pulled the frame forward and disconnected the small ashtray light. The power wire for the cigarette lighter can stay attached. After that, it was easy to replace the flasher unit.
If you're talking about how the ashtray won't close, as was the case with my car, it's a really easy fix. Inside the ashtray there is a blue 'L' shaped hook that hangs on a hinge. When the ashtray closes, the 'hook' on the 'L' grabs the ashtray so it won't open again. Then, when you push on the ashtray, the hook is dislodged and it is allowed to open. In my car (a 2002 Jeep Grand Cherokee) the ashtray wouldn't close because the hook came off. All you have to do is pull the ashtray all the way down (gently so it won't break), find the hook, and insert the hook back into the position (it is an obvious spot on the right side of the opening.) Ensure that it is allowed to slide up and down. If you've done this correctly, you should be able to close the ashtray again.