One bolt at a time-cute but not helpful
2
To replace the blower motor resistor in a 2000 Oldsmobile Silhouette, first, disconnect the vehicle's battery to ensure safety. Locate the resistor, which is typically found near the blower motor under the dashboard on the passenger side. Remove the screws securing the resistor, disconnect the wiring harness, and then install the new resistor by reversing the process. Finally, reconnect the battery and test the blower motor to ensure it functions correctly.
take a flat bar or caw hammer slid under the door cover and pired out
4.5 Quarts of oil.
To replace the passenger window motor on a 2002 Oldsmobile Silhouette, first, remove the door panel by unscrewing any fasteners and gently prying it away from the door frame. Disconnect the electrical connector and remove the old motor by unscrewing it from the regulator assembly. Install the new motor by aligning it with the regulator, securing it with screws, and then reconnect the electrical connector. Finally, reattach the door panel and test the window to ensure proper operation.
Put a potato in the exhaust pipe.
under dash on right side three bolts
standing at front of vehicle look straight to the back top of motor,
Check the ground strap between the wiper motor and the body.
take off plastic shield that goes from bottom of radiator to bottom of motor and you will see starter in bottom of motor
If one takes a look at the schematics of a 1994 Oldsmobile silhouette minivan, one can see a fuse block, washer switch, and windshield wiper. There are also the power input, washer control, motor ground, and circuit board.