To replace the camshaft sensor in a 1996 Oldsmobile 98, first, disconnect the negative battery cable to ensure safety. Then, locate the camshaft sensor, which is typically found near the engine's timing cover. Remove the electrical connector and unscrew the sensor from its mounting. Install the new sensor, reattach the connector, and reconnect the battery before starting the engine to verify proper operation.
The Camshaft Position Sensor is located behind the Power Steering Pump.
The cam sensor is part of the distributor. You have to replace the entire distributor.
in the distributor, you have to replace the whole unit.
change coil module
Locate the camshaft sensor in your car. Disconnect the electrical plug on the sensor. Remove the bolt that holds it in place. Twist the the sensor to remove it and place in the new one.
On the camshaft
Where is the Knock Sensor located on a 1996 Oldsmobile Aurora?
where is the camshaft position sensor laocated at on a 1996 ls 400 lexus
were is the camshaft position sensor (cmp) location on a 1996 caprice classic
It is in the distributor, you have to buy a distributor to replace.
did u ever figure it out?
To replace the camshaft position sensor on a 1996 Ford Ranger with a 2.3-liter engine, first disconnect the negative battery terminal. Locate the sensor, which is typically found near the engine's camshaft; it may be held in place by a bolt. Remove the electrical connector and the bolt, then pull out the old sensor. Install the new sensor by reversing the removal process, ensuring the connector is securely attached and the battery terminal is reconnected.