To replace the drivers inside the door handle of a 2001 Toyota Sienna, first, remove the door panel by unscrewing any screws and carefully prying it off. Next, disconnect the wiring harness and remove the old door handle by unscrewing it from its position. Install the new handle by securing it with screws, reconnect the wiring, and finally, reattach the door panel, ensuring everything is properly aligned. Make sure to test the handle function before fully securing the door panel.
you dont........you buy a new car.....
check out this website it tells you how to repair the handle since it cost about $65.00 to buy a new one. http://www.findonefindall.com/toyota-sienna/
How do you remove and replace the motor for the drivers side power window in a 2000 Sienna
Happened to me a few months ago. Remove the inside rear panel and pull the latch manually. Then you can unscrew the broken latch and replace it.
Which door handle? Though, I think they are all similar in that you must remove the plastic interior on the inside of the door first to get access to the inside of the door. You then unbolt the trim panel to remove it. I just replaced the rear handle on the Sienna and I know the rear works that way for certain. Removed the interior plastic panel (first had to unscrew and remove the two handles on the inside of the rear door, then the entire plastic panel just pulled right off). There were 3 bolts holding the exterior handle trim piece to the Sienna. Unbolted those and the trim popped off. Took me about 15 minutes to take the door apart, replace the handle and put all the pieces back together.
To replace the door handle on a 2004 Toyota Sienna sliding door, start by removing the door panel. Use a screwdriver to take out any screws and gently pry off the panel to expose the handle mechanism. Disconnect the old handle by unscrewing it from the door and then install the new handle by reversing the process. Finally, reattach the door panel securely and ensure that the handle functions properly.
Replace the handle. You will need to remove the door panel to replace the handle. If you can't do this yourself take it to the dealer. They should charge you about 1.0 to 2.0 hours labor to do this, plus the part.
How to replace a starter in a 2009 toyota sienna
need to know how to open the door from the outside of a previa 1992 to take off the panel
Upon further inspection, the rear door handle assembly on the 2002 Toyota Sienna IS the same as that shown on the Find One Find All website, so never mind.
There's an excellent discussion of this problem at this thread: http://www.automotivehelper.com/topic203428.htm The quick answer is that you remove the inside handle and strap, pull off the vinyl cover and replace the handle. A new handle will cost you ~$70 at a Toyota dealer, but it's still much cheaper than paying that same dealer ~$400 to do it for you.
You replace 2002 Toyota sienna fuel pump by contacting a person who knows how to replace it efficiently.