Remove the glove box, Remove the lower trim panel from the facia above the passenger side footwell and the lower trim panel from the centre of the facia.
Release the retaining clip and remove the passenger side front footwell air duct.
Disconnect the wiring connector from the fan motor, noting the correct routing of the wiring.
Working your way around the fan motor air distribution housing, undo the retaining screws, then unclip the motor from the housing
Remove the fan motor
From inside the car, reach up behind the air disribution housing, and disconnect the wiring connector from the underside of the blower resistor which is on the left hand side of the air distribution housing, unclip the resistor from the air distribution housing.
It is the resistor, replace it.
The heater blower in a 2001 Hyundai XG300 is located on the passenger side of the engine. The blower resistor will be located on the firewall.
how do i replace a heater core in a 2001 Chevrolet blazer
where is the blower motor resistor located on a ford e250 2001
How to replace a heater hose on a 2001 Oldsmobile silloute
Pull blower its up inside hole
Under the hood, on the firewall, passengers side.
You have to take half the car apart to replace the heater core
Blower motor resistor assembly is located under dash board on passenger side.
Its located in the a/c heater blower housing on the passengers side of the vehicle........
YOU CAN'T, you will have to replace the heater core itself with a new one.
Check the low speed relay and the resistor at the motor