0
First off. Leave the wheels on the bike unlike myself at least until the axle nuts are loosened. Go to ebay and buy the 56mm/ 45mm wrenches for $25, and loosen the two large nuts. There is a washer/cap covering a snap ring on the outer edge of the smaller axle nut. also now is the time to remove the right rear wheel and hub. Then remove the caliper and the chain. Put the bike on a lift or a milk crate or something and remove the left wheel. You should be able to slide it side to side a little once the nuts are loosened. remove the clip and the circlip behind the rotor. Mine was a pain, but it popped out with a little work. Good luck. I also suggest a service manual as I discovered I was missing the O-rings near the rotor mount.
What else can I help you with?
What size is stock carb on 1985 atc250r?
34mm
How do you replace a wheel berring on an 1985 Oldsmobile regency 98?
how do you replace a wheel bearing on an 1985 oldsmobile regency 98
What are some examples of Honda ATC vehicles?
In the 1980's, Honda started developing a variety of ATC vehicles, or all terrain cycles. The 1984 ATC200S and the 1985 ATC250R are just a few of the ATC three-wheelers that Honda offered. The ATC has tires developed for snow, sand, or really any terrain you want to travel.
How do you replace a wheel berring on an Oldsmobile regency 98?
how do you replace a wheel bearing on an 1985 oldsmobile regency 98
How do I change the headlight on a 1985 Honda Civic Hatchback?
The headlight on a 1985 Honda Civic is changed by lifted the hood open. Locate the housings for each headlight and find the harnesses for the bulbs. Pull out the old bulbs and replace them.
1985 Honda Accord?
It is a Honda Accord that was manufactured in 1985
How do you replace the headlight on a 1985 Honda?
To replace the headlight on a 1985 Honda, first, open the hood and locate the headlight assembly. Remove the retaining ring or screws that hold the headlight in place, then carefully pull the headlight out. Disconnect the wiring harness from the back of the headlight, replace it with the new one, and reconnect the harness. Finally, secure the headlight back in the assembly and replace the retaining ring or screws.
How do you replace a wiper linkage bearing on a 1985 Chrysler 5th avenue?
To replace the wiper linkage bearing on a 1985 Chrysler 5th Avenue, first, remove the wiper arms by loosening the nuts and lifting them off the shafts. Next, detach the wiper motor and linkage assembly from the vehicle by unscrewing the mounting bolts. Carefully remove the old bearing from the linkage, then insert the new bearing, ensuring it's properly seated. Reassemble the linkage and wiper motor, and reattach the wiper arms to complete the repair.
What is the recommended oil for a 1985 Honda atc 1985?
Eng oil capacity 1985 Honda 200 m atc?
How do you change a headlight on a 1986 Honda Spree?
To change the headlight on a 1985 Honda Spree scooter remove the headlight housing. The scooter headlight will be mounting on the rear of the housing. Remove it and replace the bulb.
When was Honda Today created?
Honda Today was created in 1985.
When was Honda Legend created?
Honda Legend was created in 1985.
