0
To replace the ignition lock on a 1985 pickup, first disconnect the negative battery terminal to prevent any electrical issues. Remove the steering column cover by unscrewing it, then locate the ignition switch and remove any retaining screws. Disconnect the wiring harness from the ignition lock cylinder, insert the new lock cylinder, and reassemble the steering column. Finally, reconnect the battery and test the new ignition lock to ensure it functions properly.
What else can I help you with?
How do you replace ignition lock 1999 vw beetle?
how to replace ignition lock for 1999 vw beetle
How do you replace an ignition lock cylinder in a 1985 Buick Regal?
You have to remove the steering wheel, and it requires special tools.
How do you remove the ignition switch in a 1988 Isuzu pickup?
how to remove lock cyliner switch 1988 Isuzu pickup
How do you replace ignition lock cylinder Isuzu rodeo?
How I can replace ignition switch cylinder from Isuzu Rodeo?.
Do you need to replace the ignition lock cylinder when you replace the ignition switch on a Pontiac Sunfire 1999?
No, not if it is not defective. If the ignition switch is defective then that is all you need to replace.
Change ignition lock on 1970 ford maverick?
How do I replace an Ignition in a 1970 Maverick
How to fix a 1996 Pontiac grandam ignition locked?
Replace the ignition lock cylinder.
Do you need to remove the ignition lock to replace the ignition switch on a 94 Honda Accord LX?
no the switch can be independly remove from the back side of the ignition lock
How do you replace a ignition key lock cylinder on a 90 Chevy pickup with tilt wheel?
Remove the steering wheel, Then remove the turn signals section. This takes some special tools.
Where is the immobilizer switch Mazda rx8 2004?
immobilizer is in the key and pickup ring on the ignition lock
How do you replace an ignition lock cylinder on a Chevy S-10?
Remove the retaining ring at the top of your Chevy S 10 ignition lock cylinder. Slide the ignition lock cylinder out. Remove the wiring harness from the back of the ignition lock cylinder. Reverse the process to install the new ignition lock cylinder.
How do you replace an ignition switch in a 1998 Saturn SL2?
Is should not be that difficult. Pickup a service manual, I believe that the Saturn uses GM's Passlock Anti-theft system. If you are having problems with the ignition or the car starting, it is more than likely thie ignition cylinder lock. This is a common problem with GM vehicles. This also should not be all that difficult to replace. There is a bit more to it than replaceing the ignition cylinder lock you will have to reprogram the system to read the new key unless you have the new lock keyed to match the original key.
