0
BLOCK THE WHEELS FOR IT WON'T ROLL OVER YOU AND KILL YOU.
Now take the 4 bolts out of the rear drive shaft U-joint, and remove driveshaft and pull it out of the transmission. Now take a screew driver and pry the seal out of the transmission tail shaft. Then take hammer and tap the new seal back in the trans. then put it all back together. YOUR DONE.
What else can I help you with?
Can you separate the transmission from the transfer case in a 4WD 1976 Chevy pickup and use the transmission in a 2WD 1962 Chevy pickup?
No. The 2wd and 4wd trans cases are compleatly different.
What kind of transmission is in 1976 Chevy c-10 pickup 2 wheel drive?
turbo 350
Where is the back up light switch located on a 1976 Chevy pickup truck?
Usually located on the transmission.
What is Value of 1976 Chevy pickup?
Check out this site, http://www.nadaguides.com/
You want to swap a 4L80e into your 1976 Chevy 4x4 pickup?
To make that transmission work. You would have to install a computer and wiring harness and speed sensors. That would be alot of money. The 4L80E is a electronic controlled transmission.
Will 1986 Chevy pickup frontend fit on a 1976 Chevy pickup?
It should, may have to swap the whole front clip. Resulting in changeing out the core support..
Is the park switch on a 1976 Chevy pickup wiper motor in the pump or the motor?
It is in the motor.
Can a 1976 Chevy transmission work for a 1998 Chevy s10 that needs a transmission?
A direct replacement, no. But with fabrication and a few bucks it could.
How do you replace blinker switch on a 1976 Chevy Corvette?
== ==
What did Chevy pickup cost in 1976?
1976 Scottsdale full size box, 4 WD, I paid $5,500.00 for mine, still have it.
How do you start 1976 Chevy pickup without key?
most older trucks can be started without a key
How much would a 1976 Chevy Cheyenne pickup that runs and needs some body work be worth?
$50
