To replace the transmission vent tube on a Turbo 350, first, ensure the vehicle is safely lifted and secured. Remove the old vent tube by unscrewing or pulling it out from the transmission case, depending on its design. Clean the area where the new tube will be installed, then insert the new vent tube and secure it in place. Finally, double-check for any leaks and ensure it's properly seated before reassembling any surrounding components.
There should be a vent tube just above the in and out oil fittings on trans. It may be hard to see if trans is installed in vehicle.
To unplug a vent tube on a 350 Turbo transmission, first ensure the vehicle is safely supported and the engine is off. Locate the vent tube, typically found on the top of the transmission case. Carefully remove any debris or obstructions around the tube, and use a small brush or compressed air to clear it out. If the tube is damaged, consider replacing it to ensure proper ventilation and function.
Please clarify your question and include make, model, year, engine size and transmission. Are you asking about an actuator for the turbo charger? The waste gate on the turbo charger? Or for the heater vent controls?
The pan gasket could be leaking ( tighten mounting bolts or replace gasket ) Filler pipe rubber seal , Transmission oil lines ( tighten , replace ) Speedometer connector ( replace o-ring ) Some makes have a transmission vent pipe ( transmission over filled ) Output shaft seal damaged (replace)
The problem ended up being the vent port in the top of the transmission housing was plugged with a mud-dobber nest. The nest was probably built when I had the transmission in storage.
On the top of the transmission.
Oil blowing out of the dipstick in a Turbo 400 transmission typically indicates excessive pressure buildup within the transmission. This can be caused by a clogged vent, overfilling the transmission with fluid, or internal issues such as a malfunctioning pump or worn seals. It's important to address these issues promptly, as they can lead to more significant damage and performance problems. Regular maintenance and checks can help prevent this issue from occurring.
How do you replace vent windowin a 2005 chevy malibu?
on the transmission
through the cener vent and to the left there clips you have to press together to slide out the switch..hope this helps
It has a vent, but it is not for over filling.
The transmission vent on a 2001 Ford Taurus is found on the engine. It is on the driver's side of the engine.