Try taking the negative battery cable loose from the battery for about 3o seconds and then put it back on and tighten it good.
This should reset it.
The light will reset itself when the malfunction detected by the computer is repaired. You need to have the system checked for codes.
if the problem is fixed, then whoever fixed it should have reset it. if it isn't fixed, fix it.
To reset the airbag light on a 2005 Honda Odyssey, first, ensure the ignition is off. Then, disconnect the negative battery terminal and wait for about 10 minutes to allow the system to reset. Reconnect the battery terminal and start the vehicle. If the airbag light remains on, it may indicate an underlying issue that needs to be diagnosed with a professional OBD-II scanner.
To reset the airbag light on a 2005 Honda Accord, first ensure the vehicle is turned off. Then, turn the ignition to the "On" position without starting the engine. Next, locate the airbag diagnostic connector, usually found under the dashboard, and use a paperclip to bridge the two terminals for about six seconds. Finally, remove the paperclip, turn off the ignition, and then restart the vehicle to see if the airbag light has gone off. If it remains on, there may be a deeper issue that requires professional diagnosis.
I Do not have jeep or one does not have an airbag
A flashing SRS light means there is a problem. It is a 2005 and the SRS is still under warranty. Take it to the dealer for repair.
The air bag light is on because there is a problem with the air bag system. Repair the problem and the light will reset itself. As long as the light is on the air bag will not function if needed.
The airbag light stays on when there is a malfunction. The airbag computer will have stored a trouble code. When the failure is repaired the light will shut itself off.
To reset the airbag warning light on the passenger side of a 2005 Jaguar XKR, first ensure that the vehicle is turned off. Then, turn the ignition key to the "on" position without starting the engine and wait for the warning light to illuminate. After a few seconds, turn the ignition off and then back on again. If the light persists, it may indicate a deeper issue that requires diagnostic tools or professional assistance.
where is the erg valve located on a 2005 DuraMax 2500
how do you reset the check engine light on a 2005 Toyota tundra
How do i reset a service engine light on a 2005 gmc c6500 cat engine