Usually this is done when oil filter is removed if not you have to go through can bus
Here is the link on how to reset and change engine oil on 08 tundra ( http://www.tundraheadquarters.com/documents/toyota-tundra-5-7-liter-oil-change.pdf )
see:- http://grumunkin.blogspot.com/2009/08/how-to-reset-service-indicator-on.html :-)
maintenance with engine
It's in the driver information screen between the speedometer and odometer. There should be an option to reset it.
If you have already replaced the belt and the light is still on you will need to remove the lower and upper dash panels and then remove the instrument cluster which holds your speedometer and other devices. The reset button for the timing belt light is behind the cluster.
Put air in tires make sure air pressure is equal in all tires
The Allure was the Canadian model. It ran from 05-08.
Virgile Reset was born on 1985-08-03.
To reset the service light on a 2008 Dodge Nitro, turn the ignition key to the "On" position without starting the engine. Press the gas pedal three times within 10 seconds. Turn the ignition off, then start the engine to ensure the service light has been reset. If the light remains on, you may need to check for any existing issues or repeat the process.
IF all tires are at the correct pressure and the light is still on, there is a failure in one of the sensors.
you need a scan tool, to hook up to the data link connector, if the light goes out it could still come back on, if the light comes back on after you reset the lite, then you have a hard fault, which means you will have to have the problem addressed. you will have an automatic fail going through emmissions if the lite is on.
the the ignition to on but not the engine running and pres the gass pedal 3 times withing 5 seconds and it will go away