There is a reset button underneath the dash just right of the hood latch. Pressing and holding will turn it off. Then let go of button and press it again and tire pressure light will flash 3 times and then reset.
On the 2006 Toyota Highlander, the tire pressure reset button is typically located beneath the steering wheel, near the driver's side dashboard. It may be necessary to look closely, as it can be somewhat hidden. To reset the tire pressure monitoring system, turn the ignition to the "on" position (without starting the engine) and press the reset button until the indicator light blinks three times.
There is a button under the steering wheel press it in for about 5 seconds and the light will go out. Then your tire pressure is low it will light again check your tire pressure inflate then push the button again.
To reset the oil change light on a Toyota Highlander 2012, switch the engine to the OFF position. Then switch the engine back on while pressing the trip meter reset button until it displays 000000 or says COMPLETE.
how do you reset the low tire pressure warning light on a 2009 camry
To reset the VSC light on a 2002 Toyota Highlander, first, turn the ignition to the "ON" position without starting the engine. Press the gas pedal to the floor three times within five seconds, then turn the ignition off. Start the engine, and the VSC light should be reset. If the light persists, there may be an underlying issue that needs to be diagnosed.
how to reset display screen after changing oil at 15000 miles. this is on a 2008 highlander.
I found a reset button under the dash board. You may want to look there first.
how to reset tire light
how do you reset the tire pressure monitoring system on a 2006 Toyota Rav4?
To reset a check engine light for a Highlander 2003, disconnect the battery for 10 minutes. After this time, reconnect the cables.
To reset the tire pressure light in a 2006 Toyota Matrix, first ensure that all tires are inflated to the recommended pressure. Next, turn the ignition to the "ON" position without starting the engine. Press and hold the tire pressure warning reset button, usually located beneath the steering wheel, until the light blinks and then turns off. Finally, turn off the ignition and then start the vehicle to confirm that the light has reset.
At the very bottom of the driver's side of the daashboard at about where the steering column goes down, there is a little push switch mounted. Depress it and hold for 5-10 seconds and it will re-set the tire pressure warning system.