Fordtransit.org/forum/viewtopic.php?f=2&t=73111&start=0 - Cachedconnect remote and clock - 5 posts - Apr 13, 2008
Flashing clock light - 4 posts - Oct 24, 2006
This was a question, not an answer.
The clock of a 2006 Volvo s40 is control via a knob on the instrumental panel. To set the clock simply turn the knob and manipulate the digits into the wanted time.
They didn't make an LTD in 2006
To set the clock in a 2004 Ford Transit, turn on the ignition without starting the engine. Press and hold the "Clock" button until the display starts flashing. Use the "Hour" and "Minute" buttons to adjust the time, then press the "Clock" button again to save the settings. If your model has a different setup, consult the owner's manual for specific instructions.
click settings use down arrow and find clock then just answer the questions it asks you and the the time will be set
Lots of 2006 trucks out there, you need to state make and model also.
To set the clock on a 2006 Honda Jazz, first turn on the ignition or accessory mode. Press and hold the "Clock" button until the hours start flashing. Use the "H" button to adjust the hour and the "M" button for the minutes. Once set, press the "Clock" button again to confirm and exit the adjustment mode.
look in your owners manual.
To set the clock on a 2006 Honda Jazz, first, turn on the ignition or the accessory mode. Press and hold the "Clock" button until the hours start blinking, then use the "Seek" or "Tuning" buttons to adjust the hours. Press the "Clock" button again to switch to minutes, and use the same buttons to set the minutes. Finally, press the "Clock" button once more to confirm your settings.
To set the clock on a 2006 Honda Civic, turn the ignition to the "On" position without starting the engine. Press and hold the "Clock" button until the display begins to flash. Use the "H" (hour) and "M" (minute) buttons to adjust the time, then press the "Clock" button again to save the settings. The clock should now display the correct time.
To set the clock in a 2006 Honda Pilot, turn the ignition to the "On" position without starting the engine. Press and hold the "Clock" button until the display begins to flash, then use the "H" (hour) and "M" (minute) buttons to adjust the time. Once the correct time is set, press the "Clock" button again to finalize the setting. Ensure to check if the time reflects AM or PM correctly after setting.
To set the clock in a 2006 Jeep Liberty, turn the ignition key to the "On" position without starting the engine. Press and hold the "Clock" button until the time display starts flashing. Use the "Tune" or "Seek" buttons to adjust the hours and minutes, then press the "Clock" button again to save the setting. Finally, turn off the ignition to complete the process.