2 to each speaker, 1 ground, 1 keyed power, 1 illumination or memory.
A car's graphic equalizer is used for the stereo. The equalizer helps you achieve a more pleasant-sounding experience from your speakers.
The red wire is the positive wire. The black wire is the ground wire. The green and yellow wires are the speaker wires. The white wire is the auxiliary wire.
The black wire is the ground wire. The red wire is the positive wire. The green and yellow wires are the speaker wires. The white wire is the auxiliary wire.
i have the same car, and the wire is either dark or light blue.
buy a wire harrnes install kit they will have collored wires that will match the line up of your aftermarket car stereo. and then you don't have to cut any of the factury wires. if you go to sell the car you can put the facutery stereo back in
Check the fuses, remote wire, and power wire first of all. If that doesn't work you might have wires loose somewhere.
http://www.modifiedlife.com/car-radio-wiring-diagram-and-car-stereo-wire-diagram-2001-saturn-sc1/ orange and yellow wires are power
The ground wire is black. The power wire is red. The speaker wires are green and yellow. The auxiliary wire is white.
If the sound system in your car just doesn’t seem to blast your music loud enough for you, it might be time to think about installing a car equalizer. A car equalizer can essentially control all of the frequency bands that come along with different radio stations, CDs, and MP3s. Without a car equalizer, you would constantly be needing to change the various levels on your player. Now that you know what an equalizer is, how exactly do you get said equalizer installed into your vehicle? The first thing that is an absolute MUST is to turn off all power sources to your car. You are going to be working mostly with the wiring and the fuse boxes when you are installing your car’s equalizer, so you most assuredly don’t want to be surprised when your car has a power surge and you are working in the fuse box. Now you are going to want to decide where you want the equalizer to be in your car. Most people are going to put them on the dashboard because it gives them an easy place to adjust the equalizer as needed. If your equalizer did not come with some form of mounting piece, you may have to use a makeshift holder to get it to stay on your dashboard. Once you have the car equalizer mounted, you will need to take some 16-gauge wire and plug it in to the panel of fuses where it says power in. You’re then going to be able to hook the main unit of your stereo system to the equalizer by running a wire from the stereo to the equalizer. You will need to remove the covering at the end of the wire that turns your unit on as well as removing the covering from the end of the wire you plugged into the equalizer. Tape these two pieces of wire together with black electrical tape. Next, you are going to need to relay the wire for turning the system on. The RCA cables originating from the main unit are going to need to be connected to the outlets of the amplifier. Take these cables so that you are putting the equalizer and the amplifier cables together. From the outlets of the amplifier, you will need to run the RCA cables to the inlets of the equalizer. After you’ve completed all of these steps, just put the main unit back into the dash, turn your equalizer on, and enjoy a most stable music experience.
your ground wire for the stereo is connected to the ignition wire of the car
If you are not happy with the sound of your car stereo, you can always buy a car audio equalizer. For the best quality sound this is a good option. It does come with a price though.
go to a place where they sell car stereos and ask for a wire harness for your van they only cost about 20 bucks and they pulg into your factory wire harness and the harness wires should be color matched to your stereo if it an after market stereo