answersLogoWhite

0

What else can I help you with?

Related Questions

How does a 4 way pneumatic valve work?

Moduflex dual valve combines two, 4-way valves into one valve body, it features two independently operated valves in the Size 1 valve body. :)


Pipe two 4 way valves together so they work separately on the same pump?

Plumb them in a series, the "out" from the 1st valve to the "in" of the second valve then the "out" from the second valve to return.


Where are the idle air control valve and the EGR valve on a 1991 Chevy Corsica 4-cylinder LS?

The idle air control valve is located on the throttle body, and the EGR valve is located on the intake manifold.


How do you replace the egr valve on a 99 Mercury Mystique 4-cylinder?

Remove the vacuum hose from the EGR valve. Pull the valve out of the air cleaner housing. Reverse the process to install the new valve.


Where is the PCV valve located on a 1998 Mazda Protege 4 cylinder?

On my 1997 Protege a hose runs from the valve cover to the air intake assembly. Where the hose connects to the valve cover is the PCV valve.


What is the recommended installation height for an air admittance valve?

The recommended installation height for an air admittance valve is typically between 4 to 6 inches above the highest point of the fixture it serves.


Where is the Schrroder Valve located on an 89 model mark vii?

Should be on the air compressor for the suspension. Under the hood on the drivers side just behind the battery is the compressor. The black cylinder with 4 air lines coming from it (these may be covered by black split-loom) is the air dryer. Look under that for the valve. It looks like a tire valve. Remember: the air bag solenoids must be open for this fill technique to work. (Key - on, Air suspension - on) If the Check Suspension light is on, the system is off.


High idle Toyota 4 runner?

clean or replace your idle air control valve.


Where is the air bypass valve on a 98 Mazda millenia?

The Air Bypass valve location is shown on the vacuum schematic decal on the bottom front of the hood. Take off the 2 or 4 bolts holding the plastic engine cover and pop off the cover. You'll then see your vacuum hoses leading to the valve. There are 2 or 3 - 1/4 inch hoses leading to the base of the valve and one or two 3/4 inch hoses attached to the valve itself


What is a 4 way hydraulic control valve?

The number is four ways in and out of oil. Way valves in the hydraulic system with a number of ways in and out of the way oil and positioning are introduced. For example, two-position four-way valve.


VALVE- My left 4 dead doesn't work on internet what do i do?

This is not a forum for Valve technical assistance. I would check with their website forums for help.


Does a 1995 Pontiac Grand Am SE with a 4-cylinder have an air release valve in the cooling system?

No air release. there is a high presure and a low pressure valve, these are used for filling refrigerant, checking pressures, and evacuating the system.