0
What else can I help you with?
What are the valve cover torque specs for a 2003 Ford ZX2?
54-70 lb/in NOT foot pounds... www.teamzx2.com
What are the big end torque settings on a 1.4 tdci Ford Fusion 54 reg?
The big end torque settings for a 1.4 TDCi Ford Fusion (54 reg) are typically around 20 Nm (15 lb-ft) for the initial torque, followed by an additional angle of 90 degrees for final tightening. It's essential to consult the vehicle's service manual for the exact specifications and sequence to ensure proper installation. Always use a calibrated torque wrench for accuracy.
What is the torque of a Suzuki Burgman 650?
The torque of the Suzuki Burgman 650 is 54-60 Nm at 5000 rpm
What is the valve clearance on a 54 plate 1.7cdti Astra?
40mm =or-5mm.
What are the torque settings for big end and main bearings on ford 3L v6 Granada?
The torque settings for the big end bearings on a Ford 3.0L V6 Granada are typically around 40-45 lb-ft (54-61 Nm). For the main bearings, the torque settings usually range from 55-65 lb-ft (75-88 Nm). It's essential to follow the specific service manual for your vehicle, as variations may exist based on the model year or specific engine configuration. Always ensure proper torque sequence and use a calibrated torque wrench for accurate measurements.
What is the torque on the brake caliper mount bolts on a 2006 kia sorento?
54 ft lb
What is the lug nut torque on a 1975 ford pickup?
MODEL: F1/2 TON F-100,150 TRUCK YEAR: 54-95OE SIZE: 15 X 6BOLT: 5X139.7LUG NUT: 1/2-RHCB: -ET: L
What are the head torque specs for a Nissan Sentra 98 1.6 GXE?
54 to 74 inch pounds, not foot pounds. Use and inch pound torque wrench.
How much does it cost to replace an alternator in a Ford Focus?
just replaced my alternator on my 54 plate ford focus cost me 15 gbp used these can also be located on ebay for as little as 17.99 gbp
Where is the ERG valve on a 1997 Ford F150 4.6L V8 Is there a free online diagram?
I found a pdf document that has a picture of the location of the EGR valve for you. [http://www.allenengine.com/46-54-truck-install.pdf www.allenengine.com] Good Luck and Remember.Change Your Mind, Not Your Oil.Use the First In Synthetic Motor Oil's.See My Bio For more information.
How much is 54 quads?
54 quads is 163.99.
What is the torque for the headbolts on a 1.6 liter motor on a 1989 Nissan Sentra 4-cylinder?
I have a 1.6 L motor, it was; torque to 21, then torque to between 51 and 54 lbs. completely loosen bolts then repeat tightening pattern above.
