Between 8,000- 12,000. I put one in last year it ran a bit over 11,000 and from what I understand it has gone up 20% since then. Make sure your unit qualifies for an rebate. Your gas/elec. company has an approved list of dealers. I didn't know this until AFTER I put mine in and I had asked the salesperson about it before I bought it. I couldn't get the rebate.
The cost to install a 7.5 ton package unit can vary depending on factors such as the complexity of the installation, location, and additional materials required. On average, installation costs for a 7.5 ton package unit can range from $6,000 to $12,000. It's recommended to obtain quotes from multiple HVAC contractors to get an accurate estimate.
$1200 to $1500 depending on the length of run
Depends on location and on what brand of unit you have. Also depends if the unit lost its freon during its failure. Cost with out freon is 1300-1600 with freon R-22 now that is has doubled in price would be 1700-2300.
how much does rutile cost per ton
$depends on if the existing ductwork can be used.
As far as I can tell, it depends on square footage and tons. It may cost you $5,000 to install a complete system. I also read that it may cost you anywhere from $1,500-$2,500 per ton.
If the only thing to replace is the unit itself, the install is not expensive. You could buy a new 13 seer 2 ton unit for around $800.00. To have someone install could be done for under $500.00 realistically. If you wire the unit, and can braze( silfoss) the liquid and suction lines and just need someone to evacuate (vacuum suck down) and charge the unit, it could be done cheaper yet...
it cost 10.00 a ton.
just the condensing unit roughly 1500to2000
53189
250 per ton
Depends but usually Around 1200.00, if it needs the freon to be refilled expect another 300-500 depending on how much it holds.