no, it will just add power.
I assume you mean the firing order? 1.3.4.2. with No 1 at the timing belt end to No 4 at the gearbox end.
where is the speed sensor on a rover 200
how do you fixs in a rover 200 tow bar and wireing
Dont know and if you are tryimg to fix it buy a new car you cheapskate
Painfully, or $$$... Seriously, one has to remove the light assembly and the grill. It's about a $200 job at the dealer. Part of Land Rover's plan to keep Rover repairs in house.
A Rover 200 can be purchased from a number of websites online such as: autotrader and carsite. Autotrader has one of the largest selection of Rover 200 vehicles on the net.
Remove gearbox to access clutch unit!
I suspect an air lock in the coolong system. The bleed screw is located on the pipe running just above the gearbox, It's an 8mm socket that fits the bleed screw.
first remove indicator lens ,screw on inside of wing.Then remove screw at side of removed lens both upper bolts and then remove nut from underneath headlight.
To remove the headlight from a Rover 200, start by opening the bonnet and locating the headlight assembly. Unscrew the retaining screws or bolts securing the headlight in place, typically found at the top and sometimes at the sides. Gently pull the headlight forward to disconnect it from the clips or brackets, and unplug the wiring connector. Carefully remove the headlight from the vehicle, taking care not to damage surrounding components.
The horn on Rover 200 Series is twin horn and is tucked away by the side of the passanger side headlight.