answersLogoWhite

0

There is 2 bolts on backside of powersteering pump 13mm loosen those and the bottom 15mm bolt loosen as well take outer belt off and then loosen idler pulley adjustment screw which i believe was 13mm loosen middle bolt on idler pulley and slide back and the old belt is off. replace and make sure belt you have is same size, i didnt realize the dip**** at autozone gave me belt for the 4 cyl. dohc which looks exactly the same and is about 2 in. shorter than the one for the 6cyl2.5

User Avatar

Wiki User

16y ago

What else can I help you with?

Related Questions

Is the timing belt and serpentine belt the same on a 2000 Chrysler cirrus?

No.


Where is flasher relay for 2000 Chrysler Concorde?

how to replace the flasher on a 2000 chrysler concorde LXI


How do you replace a serpentine belt on a 2000 Ford Escort?

do you have a diagram


How to replace the serpentine belt on 2000 ford escort zx2 dohc?

I need a diagram to replace the serpentine belt on my 2000 Ford Escort ZX2 DOHC. Where do I go to find this diagram specific to my car?


How much does it cost to replace a serpentine belt on a 2000 Chrysler town and country 3.8l?

about $125. but beware I had to have mine replace and it slipped off 4 times in the next 20,000 miles. The repair shop then use a belt 1 inch smaller than called for by Chrysler and it has stayed on for 120,000 miles. Good luck!!


Can you replace the lighter socket in the 2000 Chrysler Concorde?

yes


What do you do when your engine is locked up on your 2000 Chrysler?

Repair or replace.


How do you replace a serpentine belt on a 2000 Bravada?

if you have to ask how to replace the belt you should not open the hood take it to a shop


How do you replace the serpentine belt on a 2000 Infiniti i30?

Oil for 1997 infiniti needed


How do you replace rear struts on a 2000 Chrysler cirrus?

You take it to a shop.


Should both the radiator fan and the AC fan be running on a 2000 Chrysler Cirus when the AC is on?

When driving in city traffic, yes. Both may also run on an extremely hot day.


How do you change a ac compressor on a 2000 Chrysler cirrus?

To change the AC compressor on a 2000 Chrysler Cirrus, first disconnect the battery and recover the refrigerant from the AC system. Next, remove the serpentine belt and disconnect the compressor's electrical connector and refrigerant lines. After unbolting the compressor from its mounting bracket, replace it with the new unit, ensuring all seals are replaced. Finally, reconnect the refrigerant lines, electrical connector, and serpentine belt, then recharge the AC system with refrigerant.