answersLogoWhite

0

The only way to remove the lock is with a key, you will need to get a locksmith to make a key to the old ignition so you can install the new lock set. Forcing the lock forward will damage the column and could be very expensive to replace.

User Avatar

Wiki User

16y ago

What else can I help you with?

Related Questions

How do you start 93 Buick lesabre with bad ignition switch?

To start a 1993 Buick LeSabre with a bad ignition switch, you can try bypassing the switch using a screwdriver or a jumper wire. Locate the ignition switch connector under the steering column and connect the appropriate wires to simulate the "start" position. However, this is a temporary solution; it’s advisable to replace the ignition switch as soon as possible for safety and reliability. Always ensure the vehicle is in a safe position before attempting to start it this way.


Is there a limit on the number of continuances in a divorce proceeding?

Legally, there is probably no limit on the number of continuances in a divorce proceeding. However, sooner or later one of the sides is going to complain and the judge will likely end them.


I have a Mitsubishi Endeavor 2004 does my vehicle have daytime running lights?

My 2004 Endeavor does not. However, I like the idea, and the lights turn off when the ignition switch is in the lock position, so I leave the headlights on all the time.


Key in ignition chime stays on when door is opened and key not in ignition on 1999 Saturn SL2 can this be disabled?

yes it can by removing the switch located on the door trim. however this indicates the cylinder is not in the Locked position. The cylinder must be fully turn counter clock wise. If it cant a new cylinder may be needed


What color is ignition wire 2002 ford?

In a 2002 Ford vehicle, the ignition wire color can vary depending on the specific model and engine type. However, it is commonly a light green or dark green wire. For accurate identification, it’s best to consult a wiring diagram specific to the model in question or refer to the vehicle’s service manual. Always ensure to verify with the appropriate resources before proceeding with any electrical work.


What happens when you stick a core into a coil inductor in an undriven circuit?

If the circuit is undriven, there is no power, so inserting a core does nothing. In general, however, inserting a core into an inductor increases its inductance. Depending on the circuit, that lowers the resonant frequency.


Does this sentence need a semicolon He could not find it however hard he tried and however long he looked.?

No, it does not, and I can't see a place in which inserting one would not make it worse.


How do you turn off seat belt alert on a 2012 Hyundai?

To turn off the seat belt alert on a 2012 Hyundai, you can often disable it by inserting the key into the ignition, turning it to the "On" position without starting the engine, and then buckling and unbuckling the seat belt three times within 30 seconds. Afterward, you may need to turn the key to "Off" and then back to "On" to finalize the setting. However, this process can vary by model, so it's best to consult the owner's manual for specific instructions related to your vehicle.


What is acc position on car ignition?

The ignition switch generally has four positions: off, accessories, on, and start. Some cars have two off positions, off and lock; one turns off the car, and the other allows the key to be removed from the ignition. When the key is turned to the accessories position, certain accessories, such as the radio, are powered; however, accessories that use too much battery power, such as window motors, remain off in order to prevent the car's battery from being drained. The accessories position uses the least amount of battery power when the engine is not running, which is why drive-in movie theaters recommend that the car be left in the accessories mode during the movie.


What color is the starter wire on a 1971 chevelle?

In a 1971 Chevelle, the starter wire is typically yellow. This wire connects the ignition switch to the starter solenoid, helping to engage the starter when the ignition is turned to the "start" position. However, it's always best to consult a service manual or wiring diagram for accurate information, as colors can vary based on modifications or specific models.


What is a pointguard in soccer?

Pointguard is not a soccer position. This position exists in basketball, however.


Can you bypass the clutch ignition safety switch?

Yes, you can. However I would not recommend it.