Hard to say because no make, model or year was given. Some possibilities are, wiper transmission, wiper motor, park switch or possible switch
your motor needs to be replaced,or it could just be the module on the motor.
You need to replace the wiper motor.
No, usually there is only one.
The dalay board located on the wiper motor is defective.
Theer is probably a fuse for "wipers" in the fuse box or there is probably a plug that goes into your wiper motor; pull that plug and no wipers! If you want to disable only the auto sensing wipers part(what ever that is) Go buy a Haynes Auto Repair manual for your car. Maybe it's in there.
It's one of life's little ways of driving you crazy.
Failure of the windshield wipers on your Audi coupe can be linked to only a few possible causes. The first being that the motor that drives the wipers has failed and needs replacing. If the motor is good check all electrical connections for the motor and be sure it's properly grounded and receiving power. If the problem isn't the motor itself or the connections check to see if you have blown a fuse or fuse relay for the motor as this is the last of three possible causes of the failure.
May need new motor low speed winding may be burned out
Check the wiper motor itself. The self-parking cam can wear out, keeping the circuit connected indefinitely. There will be a fuse in the fuse box you can pull to make the wipers stop until you get the parts (the wipers won't work at all).To check the motor, turn the wipers off and disconnect the plug from the motor. Check the voltage at the plug. Only one wire should be hot. Next, turn the wipers on high. A second wire should be hot now. If you have two hot wires with the switch off, you need a relay (in the relay box) or a new wiper switch. But usually the motor is the problem.
Broken link ... there is one motor, and a connecting metal rod that moves the two wipers in harmony.
I am wondering the same thing in 1994 safari van, have only wipers on high, i've unplugged the plug at the wiper motor & checked for power, only have power to wipers on high, now is the switch in the column with the signals,
My wipers would only work on high. we replaced the signal lever which works the wipers too. i did get my mechanic to do it because it was'nt as easy as the parts store said it was. try replaceing the wiper pulse relay board under driver side dashboard