0
What else can I help you with?
How do you fit Yamaha r1 muffler to Yamaha r6?
make a piece of tapered pipe to fit from one muffler to the other then weld them together.
Stretch a piece of rubber band The rubber band becomes?
compressed spring
A cubical piece of rubber 2cmx2cmx2cm is found to have a mass of 12g What would be the mass of a cubical piece of rubber of dimension 4cmx4cmx4cm?
96 g
Ac draining on floor on a 96 Chevy cavalier?
Your drain is clogged.Under the hood on the fire wall on the passenger side beside and alittle below the drier(shiny round tank looking thing) there is a rubber drain that is shaped like the letter "L". Poke a little piece of wire in that rubber "L" and ream it out. The piece of wire should be about 6 inches long.Or if you have compressed air blow it out.
What parts of a torch are insulators?
The Insulators in a torch is the rubber. I think.
If you rub hard rubber with piece of wool what charge is on the piece of rubber?
The hard rubber would acquire a negative charge as electrons move from the wool to the rubber. Wool has a higher tendency to lose electrons, leaving the rubber with an excess of electrons and thus a negative charge.
How are bridges constructed?
I would say they are welded together piece by piece, but I'm not sure entirely. I did find a website for you to check though, en.wikipedia.org/wiki/Crane_(machine).
How do you repair a broken door hinge on a 1991 Cherokee Briarwood where it should be welded onto the frame?
To repair a broken door hinge on a 1991 Cherokee Briarwood, a new piece of metal should be welded in to hold the hinge. Then, a new hinge should also be welded in that is aligned with the door pin.
What is a word that means a piece of rubber that stretches?
flexibly
How do you remove resinator in muffler?
the resonator is a separate part of the exhaust system not part of the muffler it is to change the tone of an engine sound some are mounted before the muffler and some after the muffler if you really want to remove it cut it off with a sawsall or chain cutter and weld in a piece of pipe or look at a aftermarket exhaust catalog many replacement pipes omit resonator's.
How are bridge cranes constructed?
I would say they are welded together piece by piece, but I'm not sure entirely. I did find a website for you to check though, en.wikipedia.org/wiki/Crane_(machine).
A piece of rubber put on to the opening of a test tube?
its a bung
