the heater core hoses run into the car through the firewall behind the engine
on the fire wall under hood behind motor a silver pop can looking thing with 1 line on top and one on bottom on the fire wall under hood behind motor a silver pop can looking thing with 1 line on top and one on bottom on the fire wall under hood behind motor a silver pop can looking thing with 1 line on top and one on bottom
The egr valve is located right under the air intake line right behind the center of the motor by the fire wall
Behind the fuel line on the right side of the motor.
Lower passenger sdie of the fire wall, look behind the power steering pump.Lower passenger sdie of the fire wall, look behind the power steering pump.
Open hood, look to make sure you have water in the water container, If not add water. if you have water in the container, Then get back in car and start washer motor with switch, listen for motor noise, if no washer motor noise then you have no power to the motor, check fuse. if your washer motor starts then inspect the water lines to the window spray nozzles, starting at water container to fire wall. if all is good then they should work. the only other thing I can think of is the filter on the end of the pick up line in the water container is clogged with dirt. Good luck.
To run a water line for a fridge, you will need to connect a water supply line to the fridge's water inlet valve. This typically involves drilling a hole in the wall behind the fridge to run the line from the nearest water source, such as a kitchen sink or a water line. Make sure to turn off the water supply before connecting the line and check for leaks once the line is installed.
same thing happened to me. it is the antifreeze return line. rubber hose. access the oil filter spot and connects radiator to water pump i think.
it depends on your hull, your lower trim plate should ideally be in line with the line of the keel of your boat.
If you suspect a water line behind your fridge is leaking, you should immediately turn off the water supply to the fridge, move the fridge away from the wall, and inspect the water line for any visible signs of damage. If you are unable to identify or fix the issue yourself, it is recommended to contact a professional plumber to assess and repair the water line to prevent further damage.
To install a water line for a fridge, you will need to first locate a nearby water source, such as a kitchen sink or a water line in the basement. Next, shut off the water supply and connect a water line to the source using a saddle valve or a T-fitting. Run the water line behind the fridge and secure it in place. Finally, connect the water line to the fridge's water inlet valve and turn on the water supply to test for leaks.
To connect the water line to your fridge for water and ice dispensing, you will need to locate the water supply line near your fridge, typically behind the refrigerator or under the sink. You will then need to install a water line kit that connects the fridge to the water supply line. Follow the manufacturer's instructions carefully to ensure a proper and secure connection.
The big difference is that the synchronous motor's rotor can have a variable current applied to it through its field slip rings. Both types of motors have their own advantages. With a synchronous motor in the system, the systems power factor can be regulated.