it's on the right front of the engine, not far from the crankshaft sensor
right front of motor
To replace the knock sensor on a 2005 Dodge Durango, first disconnect the negative battery terminal to ensure safety. Locate the knock sensor, which is typically found on the engine block or oil pan, and remove any components obstructing access. Unplug the electrical connector from the sensor, unscrew it using the appropriate socket, and then install the new sensor by reversing the steps. Reconnect the electrical connector and the battery terminal, and check for proper operation.
It doesn't have one.
it sits just below the intake manifold...hard to get at .
I don't believe it has a knock sensor.
knock sensor location
Well, replacing the knock sensor on a 2005 Dodge Ram 1500 is a bit like painting a happy little tree. First, locate the knock sensor on the engine block, usually near the cylinder head. Then, carefully disconnect the electrical connector and remove the old sensor. Finally, install the new sensor, reconnect the electrical connector, and you'll be back on the road creating your own masterpiece in no time. Just remember, there are no mistakes, only happy accidents.
knock sensors on a 2005 silverado are located under the intake manifold
There are 2 knock sensor under the intake manifold, You will need to remove the intake to get to them.
The coolant temperature sensor on a 2005 Dodge Neon is located on the cylinder head. It is close to the camshaft position sensor.
Yes, a Dodge Neon has a coolant temperature sensor.
where is the transmission fluid pressure sensor located o a 2005 dodge grand caravan