If it is leaking trans fluid into the coolant it can cause overheating.
NO.
Depends. A radiator in a car looks different from a heating radiator in a building. Which one?
A radiator in a heating system uses conduction to transfer heat from hot water or steam to the surrounding air. The hot water or steam flows through the radiator, heating up the metal fins, which then warms the air in the room through conduction.
Sure, here's a sentence for you: The heating system's radiator conduction efficiently transferred heat throughout the room, keeping it nice and toasty during the cold winter months.
Your radiator may not be heating up properly due to issues such as air trapped in the system, a malfunctioning thermostat, low water levels, or a faulty water pump. It is important to have a professional inspect and diagnose the problem to ensure proper heating in your radiator.
The best place to install a radiator for optimal heating efficiency is under a window. This placement allows the radiator to counteract the cold air that comes in through the window, resulting in more efficient heating.
To bleed a radiator properly for optimal heating efficiency, follow these steps: Turn off the heating system. Locate the radiator bleed valve, usually found at the top of the radiator. Place a towel or container underneath the valve to catch any water. Use a radiator key or a flat-blade screwdriver to slowly open the valve. Listen for a hissing sound, which indicates air escaping. Once water starts to come out, close the valve. Check the pressure gauge on the boiler and top up if necessary. Turn the heating system back on and check that the radiator is heating evenly. By bleeding your radiator properly, you can remove trapped air and ensure that your heating system operates efficiently.
Over-obvious answer? Your radiator, or one of your radiator hoses, leaks - badly.
It could be because of a bad thermastat, a clogged hose, maybe a collapsed hose, you could also try cleaning the radiator. Or it could possibly be the radiator itself.
To replace a radiator valve in your home heating system, first turn off the heating system and drain the radiator. Use a wrench to loosen and remove the old valve, then clean the threads on the pipe. Apply thread sealant to the new valve and screw it onto the pipe, tightening it securely. Refill the radiator with water, bleed any air from the system, and turn the heating system back on to test the new valve.
never heard of a radiator cord - is that something you pull to get it started ??
A heating system that uses radiators to transfer thermal energy is typically a hydronic or steam heating system. In these systems, hot water or steam circulates through the radiator to transfer heat into the room. The radiator then emits heat into the surrounding space, providing warmth.