answersLogoWhite

0

What else can I help you with?

Related Questions

Where is manifold runner located dodge caliber?

On the end of the intake maifold.On the end of the intake maifold.


Will a cracked maifold make a 2001 kia sportage engine run hot?

if it is the intake manifold YES, exhaust manifold NO.


Where is the coolant temp sensor located on a 91 4.3?

Should be on the front of the engine block, if you have a vortec it is on the lower maifold below the EGR valve.


Where is the PCV valve on a ford puma?

i have a 1.4 puma,i think its between inlet maifold pipes,there should be 2 hoses going into manifold and 1 in the middle going to the valve the hoses join on a T shape,my hoses collapse when engines running and kicks out black smoke


Where is the mass air flow sensor at on a 95 Nissan pickup?

locate the air box where the air filter is, and follow the tube that goes into the intake manifold on the engine, and you should run into it befor you hit the intake maifold and it has a wire hooked into it from wire harnest


Where is the oxygen sensor located on a 2003 Kia Rio?

the lamba sensor is located inside the maifold


Where is PCV valve on 91 subaru legacy?

it is screwed in to the intake maifold on the air box side of the engine


1980 Chevy turbo 350 transmission will not go in gear?

pour some transmission fluid in the dipstick hole 2 litres will do it. you may have a leak, any evidense of red fliud at the vacuum pipe that connects the modulator valve to inlet maifold, at manifold end, if so change modulator (externally mounted on tranny)


What does it mean by look on the top of the intake manifold you are trying to figure out the correct firing order for the plug wires for a 98 Dodge Durango with a 5.6 liter V8 319 in it?

generally means that the firing order is written on top of intake manifold the numbers will be cast in the maifold at manufacture and will look like this,--1-3-4-5-6-2-7-8, may also havinve firing order written there do not use the numbers as i have written them, they are just an example


Spark plug location on a 95 Saab 900SE you cannot locate the 3 spark plugs that are in the rear of your Saab 900 se engine the wires seem to disappear under the maifold or something any ideads how do?

AnswerCertainly!! A piece of cake if you remain meticulous! Do have handy a pen and piece of paper to insure you maintain the order of the steps you take to remove the manifold cover. The manifold cover has 7 bolts that must be removed from the top of the manifold cover. Be careful!! There is 1 remaining screw on the back of the manifold to hold it in place in the rear of the engine compartment. The throttle assembly is also attached the the rear of the manifold cover. Be careful not to rock it back too hard as to displace something in the rear. A second person if good to have; a third hand is a must. I used a short 2x4 to keep the manifold cover propped up while I changed the spark plugs AND the valve cover gaskets. Good luck, swaabee


1999 ford ranger 2.5l how do you change the back 2 plugs in the back driverside?

Remove the intake maifold upper intake plenum


Where is the oxygen sensor located on a 1994 Pontiac Bonneville?

Try looking at the back of the engine on the maifold just before it connects to the exhaust pipe.