no, you cannot reset the brake maintenance light until you get NEW BRAKE sensors.
-Seven11
The brakelight sensor is located on the brake switch, which is on top of the brake pedal and held on with a 14mm jam nut.
my brake light s don't work but the fuses are good
There is no brake light sensor. There is however a brake light switch. It may be mechanical, which would be located somewhere on the brake pedal lever. It can be bad or just out of adjustment. It can also be a pressure switch located on the master cylinder.
To reset the brake warning light on a 2002 Mercedes S430 after replacing the brake pads, you typically need to use the vehicle's onboard diagnostics system. Start by turning the ignition key to the "ON" position without starting the engine. Then, press the accelerator pedal three times, which may reset the warning light. If the light persists, you may need to use a diagnostic scanner to clear any stored codes related to the brake system.
It could be a fuse , a sensor , or some other problem with the anti-lock braking system ( as long as the " brake " light in your dash is not on , you still have " normal " braking ) it means air brake system and it has something to do with your brakes. unhook the battery cable and let it reset and that will tell you for sure if you have something wrong let it reset for 15 minutes
The abs light came on because there is a problem with the abs ( Anti-lock Brake System). The abs light will not reset until the problem has been fixed. Once the abs system is repaired the light will reset itself.
It could be a fuse , a sensor , or some other problem with the antilock brake system ( as long as the red " brake " light in your dash is not on you still have " normal " braking )
Disconnecting the battery may reset the brake pad worn sensor light on a 2002 VW Beetle. Another thing to check is the harness, if it is not plugged in after installing brake pads the sensor light will go on.
the sensor is in the brake pad itself, it clips in top of brake pad
brake light flashing on 2002 jetta tdi
how to change a brake light on 2002 Nissan altima
The brake light sensor on a 2002 Lexus RX 300 is typically located on the brake pedal assembly. It is usually a switch that engages when the brake pedal is pressed, signaling the brake lights to illuminate. To access it, you'll need to look under the dashboard near the top of the brake pedal. If you're having trouble locating it, consulting the vehicle’s service manual can provide more specific guidance.