sounds kind of early
so better get new seals too
No, you should not. You are either tightening the wheel bearing to tightly or too loosely or the bearing race needs replacing. Take the vehicle to a professional and see what is wrong.
the library should have a shop manual for this vehicle :)
A wheel hub is the part of the wheel that attaches to the vehicle's axle and holds the wheel in place. A bearing is a component within the wheel hub that allows the wheel to rotate smoothly. The bearing reduces friction and wear on the wheel hub, which can improve the vehicle's performance by allowing for smoother and more efficient movement of the wheels.
It is not recommended that you replace the wheel bearings on your Hyundai Accent by yourself. Rather you should take the vehicle to a repair shop or to the dealer where you bought the vehicle for servicing.
Get a manual for this vehicle.
Vehicle type and year is essential for proper answer.
If it is a rear wheel drive vehicle it is either low oil in the rear end or an axle bearing. On a front wheel drive vehicle it is probably a bearing.
To replace the rear wheel bearing on a 2006 Chevrolet Aveo, start by securely lifting the vehicle and removing the rear wheel. Next, detach the brake caliper and rotor to access the wheel bearing assembly. Use a socket to remove the hub nut and then press out the old bearing using a bearing puller. Install the new bearing, reassemble the hub, rotor, and caliper, and finally reattach the wheel before lowering the vehicle.
The Honda accord rear will bearing should be torqued at 60 pounds. You can ruin the wheel bearing or the wheel seal if you over torque the wheel bearing nut.
To replace the front wheel bearing on a Mazda Tribute, first, lift the vehicle and remove the front wheel. Next, disconnect the brake caliper and rotor, then remove the hub assembly by unbolting it from the steering knuckle. Once the hub is removed, press out the old bearing using a bearing puller, and press in the new bearing. Reassemble the hub, rotor, and caliper, then reinstall the wheel and lower the vehicle.
To replace a Mercury Milan rear wheel bearing, first, safely lift and support the vehicle, then remove the rear wheel. Next, detach the brake caliper and rotor to access the wheel bearing assembly. Use a socket set to remove the bearing hub assembly from the knuckle, and press the new bearing into place, ensuring it's secured properly. Finally, reassemble the brake components, reattach the wheel, and lower the vehicle.
To replace the wheel bearing in a Mitsubishi L200 Ute, first, lift the vehicle and remove the wheel. Disconnect the brake caliper and rotor, then remove the hub assembly. Use a bearing puller to extract the old bearing and install the new one, ensuring it is properly seated. Reassemble the hub, rotor, and caliper, then securely attach the wheel and lower the vehicle.