If your 4WD gage comes on it is because it takes some time to switvh into 2WD.
The 4WD shift indicator on your 1998 Infinity QX4 may stay on due to a malfunction in the 4WD system, such as an issue with the transfer case, a faulty switch, or a problem with the vehicle's sensors. It could also indicate that the vehicle is in 4WD mode and not shifting back to 2WD properly. It's advisable to check for any diagnostic trouble codes (DTCs) using an OBD-II scanner or consult a mechanic to diagnose and resolve the issue. Ignoring the indicator could lead to further damage to the drivetrain.
there is a small string ,and spring connecting the gear selector needle, and the shift collar on the steering column. that is what has to be replaced. you should be able to remove parts of the dash to get to it. It usually isn't a big job.
You may need to change the indicator bulb, that's what was wrong with mine.
If the indicator stays on all the time, the vehicle thinks the seatbelt is not connected. The reason for this is probably a faulty sensor in the seatbelt handle, where you connect and disconnect it. The problem may just be some dirt on the contact.
Bewitched - 1964 Santa Comes to Visit and Stays and Stays - 6.14 was released on: USA:18 December 1969
Bewitched - 1964 Santa Comes to Visit and Stays and Stays 6-14 is rated/received certificates of: Australia:G
No, Red never comes home. Red permanently stays on Mt. Silver. The reason is unknown to everyone.
Bewitched - 1964 Santa Comes to Visit and Stays and Stays 6-14 was released on: USA: 18 December 1969
It comes on and stays on when the computer has detected a malfunction and set a code.It comes on and stays on when the computer has detected a malfunction and set a code.
Short in dash cluster is common on mazda tribute
That light is the failure indicator for the electronic throttle control system. If the light stays on, the engine computer will have stored a trouble code.That is the indicator for a failure in the electronic throttle system.
fit a new indicator column switch