Base ignition timing is 5 degrees advanced +/- 1 degree. I've attached some links below for additional information.
121 hp
4x4 = 4.3
I have a 1992 B2600i 4x4. It's an automatic. I get about 17mpg on a good day.
61 - 69 ft-lb
I found a listing for a 1988 Mazda B2600 ( 2.6 L 4 cylinder engine / 3 speed automatic transmission / 4X4 ) and listings for 1990 through 1993 Mazda B2600I ( 2.6 L 4 cylinder engine / 4 speed automatic transmission / 4X4 )
The fuel pump relay on a 1990 Mazda B2600i 4x4 is typically located in the engine compartment, near the battery or in the relay box. You may need to consult the vehicle's service manual for the exact location, as it can vary slightly depending on the specific configuration. It's usually labeled, making it easier to identify among other relays.
NO, the Mazda B4000 is basically a re-badged Ford Ranger. The 4.0 L engine has a timing chain and not a belt.
You will need to connect the tach to a ground and +12v source, the signal wire will have to be connected to the ground on the coil. Since the truck is fuel injected, you will likely have to find a way to wire it in with the connector on the coil. Kyrasis6 Mazdatruckin.com
yes
What is the timing marks for a 1998 350 Big Bear 4x4
horn circuit mazda bt 50
The 1994 Nissan 4x4 2.4 four cylinder has a timing chain.