Not possible
Put your seat belt on
When why open my Chrysler 300 door with key and the alarm goes off I immediately put key in the ignition and turn car on, the alarm quits instantly
as long as the lug pattern is the same and the tires dont scrub when you turn it should be fine.
To reset the tire sensors on a Chrysler Town and Country van, first ensure that all tires are properly inflated to the recommended pressure. Then, turn the ignition to the "ON" position without starting the engine. Press the gas pedal three times within 10 seconds, then turn off the ignition. Start the engine, and the system should reset, indicating that the tire pressure monitoring system is recalibrated.
Any engine codes, check cam and crank sensors.
2005 Chrysler 300C turn signal light bulb replacement: Purchase the correct replacement turn signal light bulb(s) first, before disassembling the vehicle. See sources and related links below for replacement bulb information. Then consult your owner's manual for the turn signal light bulb replacement procedure. As simple as it sounds, the owner's manual is the best place to start for bulb replacement instructions and illustrations. You may want to consider replacing both left and right at the same time in order to keep brightness and color equal (optional).
Turn the headlight switch on and press it in.
Pressure sensors work in all weather. In winter, the air temperature inside and outside the tire is lower. Lower temperature results in reduced air volume which causes the tire pressure to reduce. This in turn will trigger a sensor fault. Just need to add air pressure back to specification
Underneath the trim, they are the same cars. They use the same engines, and transmissions. So picking the better car depends on which front grill and interior you like. Well, I think there's more to it. Asthetically speaking, I think the 300C is the better choice. I heard somewhere that the charger's transmission was a little more aggressively tuned, and that the 300C got better mileage due to a unique HEMI design utilizing a pushrod vent on the side of the engine that allows for better airflow. If it came down to looks, though, I would say the charger.
Yes I need the code
Yes a lack of back pressure can cause the oxygen sensors to read improperly, which would turn the check engine light on.
To reset the tire pressure light on a Chrysler Pacifica, first ensure that all tires are inflated to the recommended pressure, including the spare tire if applicable. Then, turn the ignition to the "On" position without starting the engine. Press the gas pedal three times within 10 seconds. The tire pressure light should turn off if the system recognizes the correct tire pressures. If it remains on, you may need to drive the vehicle for a few minutes to allow the system to recalibrate.