0
What else can I help you with?
Where is the ecu on Mazda b2600i truck?
Under the drivers seat
95 blazer vacuum schematic?
where dose the vacuum under the battery come from
Where is the oil sending unit located on 1992 Mazda b2600i?
Right under the intake manifold. Above the starter. Tucked in there you will see a yellow/red wire leading right to it.
Where can you find 2004 Chevy silverado vacuum lines schematic?
There is a sticker under the hood somewhere that will show you where thay go.
Where can we obtain a Vacuum Line Schematic for a 1997 Chevy S10 PU 22 my manuals do not show any help?
Diagrams are usually located on a sticker under the hood. If not, get a motor manual with vacuum diagrams in it.
What does the Mazda B2200 vacuum control valve do?
The vacuum control valve releases pressure in the float bowl under hot driving conditions. See the links below for additional information.
Where is the freeze plugs on a 1992 B2600i Mazda?
I just popped mine out on a 1990, I hope. It was only about 30 Fahrenheit, I think. Anyway, the fluid is pouring out of a round hole under the drivers side exhaust manifold. All I had to remove to see it was the cowling. Wish me luck and the same to you.
Where is th egr valve on a 1997 Ford Crown Vic?
By the vacuum assembly. Look on the hood or somewhere under the hood / engine compartment for a schematic, or just pull it up online or in a Haynes repair manual
Where is the main relay on a 2002 Mazda Protege?
The main relay is in the fuse panel located under the hood on the driver's (left) side. Original equipment relay is green. Schematic decal is on the inside of the fuse box cover.
Help your 1985 Mazda 323 Hatch is running really rough the revs are jumping over 1000 and then dropping down to 500 constantly Why is it doing this?
You may have a large vacuum leak, Check under the hood for disconnected or cracked vacuum lines.
Why 1992 Mazda B2600i will not crank?
There is a clutch switch under the dash attached to the clutch pedal. This switch interrupts the start position of the ignition key, often this switch, or something in the circuit goes bad not allowing the starter to get the power it needs to start. Also check that you're starter solenoid is good. K6 Mazdatruckin.com
How do you replace the pcv vacuum hose on a 2003 Mazda 6 4 cylinder?
The PCV vacuum supply hose is located under the intake manifold. It is not uncommon for this hose to tear and create a vacuum leak. Removal of the intake manifold is needed in order to get access to this hose as there is not enough room to get hands or tools into that small area.
