0
What else can I help you with?
Where is the diagnostic com port on a 2004 vauxhall corsa twin-port?
The diagnostic COM port on a 2004 Vauxhall Corsa Twin-Port is typically located under the dashboard, near the steering column. It may be covered by a plastic panel, so you might need to remove that for access. Look for a rectangular connector that is often referred to as the OBD-II port.
Where is the obd diagnostic plug on a 2003 Vauxhall zafira?
where is the obd diagnostics plug on a 2006 vauxhall zafira?
Where is the obd connector in the Chrysler 300?
The OBD connector is under the dash on the driver side.
Where is obd connector on Suzuki swift 2008?
The OBD connector is under the dash on the driver side
Where is the OBD ll connector for a 1988 dodge dynasty?
1988 is OBD 1 not 2. The connector is under the hood, next to the battery.1988 is OBD 1 not 2. The connector is under the hood, next to the battery.
Where does the obd 2 hook up on a dodge ram truck?
The obd II connector is under the dash on the driver side.The obd II connector is under the dash on the driver side.
Where is the OBD connector on a 2000 Dodge Durango?
The OBD plug is a sixteen pin connector under the dash on the driver side.
Where is the obd-1 or obd-2 connector on your 1996 Mercury Sable?
The 1996 Mercury Sable the OBD 2 connector is under drivers dash next to kick panel
Where is the OBD II connector on a 1991 Dodge Dakota?
A 1991 Dakota would have an OBD-I connector. It is on the passenger side of the firewall. It is roughly square on the outside.A 1991 Dakota would have an OBD-I connector. It is on the passenger side of the firewall. It is roughly square on the outside.
Obd 1 connector on 1994 mustang 5.0?
The 1994 5.0L ford Mustang and 3.8L Ford Mustang used the OBD-II connector under the drivers dash. These were the first OBD-II Ford cars. They are NOT OBD-I.
How do you reset a vauxhall corsa fault codes in ecu?
To reset fault codes in a Vauxhall Corsa's ECU, you can use an OBD-II scanner to read and clear the codes. Connect the scanner to the OBD-II port, usually located under the dashboard near the driver's seat, and follow the prompts to erase the stored fault codes. Alternatively, disconnecting the car battery for about 15 minutes can also reset the ECU, but this may erase other settings. Always ensure that the underlying issue is resolved before clearing the codes to prevent reoccurrence.
Is 1994 Dakota 3.9 OBD II?
No it is OBD 1 and the connector is under the hood.
