similar complaint on Astra 1996
caused by Fuel pump malfunction
Replaced pump motor and filter the car ran perfectly around 3 days ago i replaced the steering collum and the ignition system because of someone trying to break into my car now it wont start instead all i get is a orange flashing light with a engien simbol with a power sign in the middle any ideas ???
To reset the service light on a 2009 Vauxhall Corsa, turn on the ignition without starting the engine. Press the gas pedal three times within five seconds. Turn off the ignition, then start the engine to check if the service light has reset. If the light remains on, the process may need to be repeated.
check out youtube/ scotty kilmore why car wont start
To start a Vauxhall Corsa 1.2, ensure the vehicle is in neutral (or park for automatic), then insert the key into the ignition. Turn the key to the right until the dashboard lights illuminate, and then continue turning until the engine starts. If equipped with a start button, press the brake and then the button to start the engine. Make sure to check that the immobilizer light goes out after starting.
crankshaft position sensor get a new one stick it on problem solved
that normally means the chip in your key has to be programed or the chip has stop working so u might need a new chip
if the timing belt has broke on a vauxhall corsa 1.4 will the pistons hit the valves
replace the crank shaft sensor cheap and easy
To start the new Vauxhall Corsa automatic, ensure the vehicle is in 'Park' (P) or 'Neutral' (N) and press the brake pedal. Then, press the start/stop button on the dashboard while keeping the brake pedal depressed. If your model has a traditional key ignition, insert the key and turn it to start the engine. Once started, you can shift the gear selector to 'Drive' (D) or 'Reverse' (R) to begin driving.
Change the gearbox oil and see if that helps. If it doesnt it will be the gear selection sensor.
That light flashes when there is a malfunction in the sentry key system. You could have the wrong or a failed key.
To reset the service indicator on a Vauxhall Corsa, first, turn on the ignition without starting the engine. Press the gas pedal fully three times within five seconds. Turn off the ignition and then start the engine to check if the service indicator has been reset. If successful, the service light should no longer be illuminated.
To unblock the washer jets on a Vauxhall Corsa, start by inspecting the jets for any visible debris. If they are clogged, use a fine needle or a pin to gently clear the nozzle openings. Additionally, check the washer fluid reservoir and the tubes for any blockages or kinks. If the issue persists, ensure the washer pump is functioning properly and that there is sufficient fluid in the reservoir.