answersLogoWhite

0

just the slave cylinder, for your brakes.

User Avatar

Wiki User

13y ago

What else can I help you with?

Related Questions

What all does the heaters master cylinder control in a car?

a heater does not have a master cylinder; 'master cylinder' goes with assisted braking.


Your clutch is leaking on the inside of your car?

The gasket to your clutch master cylinder is probably broken or cracked. or your master cylinder is bad.


Where is the cruise control switch located for the Lincoln town car 93?

The cruise control switch on a 1993 Lincoln Town car is attached to the master brake cylinder under the hood. Ford had a recall on this car because the cruise control switch could lead to a fire.


Can a leaking master or slave cylinder cause a car not to turn over in a manual transmission car?

No


Where is the clutch master cylinder situated and how do you remove it?

Make of vehicle would help, but almost all clutch master cylinders are beside the brake master cylinder on the drivers side of the engine compartment on the firewall. The clutch is the one closer to the center of the car. There will be a pin on the inside that connects the rod in the master cylinder to the clutch pedal and two or four bolts holding it to the firewall.


How does a master cylinder on a car break?

They don't really break. The internal seals deteriorate and fail. This results in the master cylinder not holding pressure. The repair is to replace it.


What car part did Jacob need to finish his car?

Jacob needed a master cylinder to finish his car in Twilight.


Where is the shift solenoid located on a 1992 S1 Saturn Car?

There is no shift solenoid. There is a Master and slave cylinder instead. Master slave cylinder is bolts underneath the Brake Master cylinder. The slave cylinder is here: http://www.youtube.com/watch?v=AtrTcX8wym8 Video provided by Richpin :) -RC-


1973 Volkswagen master cyl location?

The master cylinder is typically on the driver's side of the VW. Usually, if you crank the wheel really far to the right, you can see and even reach the master cylinder without jacking up the car.


1991 Pontiac grand am stalls even after master cylinder replaced?

The brake master cylinder has nothing to do with the way the car runs. It certainly wouldn't cause it to stall.....Maybe the brake booster?


Why would a 1995 eagle talon stick shift not shift at all unless car is off?

Not necessarily, it could be a number of things, master cylinder, slave cylinder, air in the lines, clutch ( has a new clutch, master, and slave cylinder btw) and multiple other things ---- well i dont exactaly get what youre saying here if you mean you start the car and it wont go into gear that a bad klutch


What is car brake system?

The brake system is what stops the car. It includes the master cylinder, ABS pump if so equipped, control module if so equipped, and the various lines, hoses, calipers, pads, etc., that provide the stopping power.