Discharge line
z
Change the indoor filter, wipe the indoor unit down, and spray off the condenser
Discharge line
You don`t size a condensing unit to match your indoor unit. You size it to match the rate at which your house gains heat (heat load). Then you buy a matching indoor evaporator coil and set the fan speed on the indoor unit to deliver the proper cfm to support whatever size condenser the heat load calculation says you needed.
No, it is not recommended to use a two-phase indoor unit on a three-phase circuit. The mismatch in phases can cause the unit to malfunction or damage the equipment. It is essential to ensure that the indoor unit is compatible with the electrical supply to prevent any issues.
In a heat pump system, the indoor unit is not called the evaporator because it serves a dual function as both the evaporator (during cooling mode) and the condenser (during heating mode). The indoor unit absorbs heat from the indoor air during heating mode and releases it into the indoor space, while it absorbs heat from the indoor space during cooling mode and releases it outside.
Watering cans are used to water indoor flowers.
420 degrees fahrenheit
Installing an indoor heat pump unit in a residential setting can provide benefits such as energy efficiency, cost savings on heating and cooling, improved indoor air quality, and consistent temperature control throughout the home.
The coil that serves the inside of the house is called the indoor coil. The reason is that the indoor coil is a condenser in the heating mode and an evaporator in the cooling mode.. (pg. 1077)
Clean your indoor & outdoor coils