0
What else can I help you with?
What are the ignition point gap settings for a 1972 Chevy 350 engine?
30 degrees dwell
Point gap settings for 350 Chevrolet engine?
what is point setting for chev 350 v8 engine Use dwell meter to set the gap to 30 degrees dwell.
What are the ignition point gap settings for a 1973 Chevy 350 engine?
a 1973 Chevy truck has HEI Answer And if it does have points, say not the original engine, its .018-.019 will do.
WHAT IS THE ignition timing and point settings on a 1968 289coupe 5lt v8 mustang?
www . motorcraft . com ( no spaces ) lists: 1968 Ford Mustang - 289 cubic inch V8 engine Ignition timing is ( 6 degrees BTDC ) Point gap is ( .021 ) Point dwell is ( 24 - 29 ) unless the engine compartment decal shows different
What is the ignition point gap settings for a 1977 Chevy love 4 cylinder?
That truck should have electronic ignition, no points.
The ignition point gap settings for a 1968 Chevy camaro 4 speed 350?
0.019
What is the ignition point gap settings for a 1977 Chevy luv 4 cylinder?
30 degrees.
What is the point gap settings on a 318 mopar engine?
.o17 is about right
What is point gap settings for 350 Chevrolet?
.019 or set dwell at 28 to 32 degrees, check timing afterwqrds.
What is point gap for lawnboy model 3058?
The point gap for the Lawn Boy model 3058 typically refers to the recommended spacing between the ignition points in the engine's ignition system. For this model, the point gap is usually set at around 0.020 inches (0.5 mm). It's important to consult the owner's manual or a service guide for specific adjustments, as proper gap settings can affect engine performance and starting. Always ensure the engine is turned off and cool before making any adjustments.
Does a 1968 Chevrolet Impala have a fuse for the ignition the car doesn't seem to be getting power to the coil?
There isn't a fuse for the ignition. You need to check the point and condenser. The dwell is 30 fegrees.
Distributor point settings 350 Chevrolet?
0.19 for brand-new points 0.16 gap for used points. The above answer may be adequate to get the engine running, but points are set correctly when you have a reading of 30 degrees on a dwell meter.
