ignition timing marks are on front cover above crank pully. Timing belt marks, above crank gear at 2 o'clock position there is a notch, and top cam gear has hole which lines up with hole in cover with 1\8 drill bit.
You will be able to see it when you remove the Bumper.
on the harmonic balancer, at crank shaft
In 1986 it dropped to $4,995.
To align the timing marks on a 1980 Honda Prelude 1.8, first, remove the timing belt cover to access the timing gears. Rotate the crankshaft using a socket and ratchet until the crankshaft's timing mark aligns with the "T" (top dead center) mark on the engine block. Ensure that the camshaft's timing mark is also aligned with its corresponding mark on the cylinder head. Once both marks are aligned, you can proceed with setting or replacing the timing belt as needed.
timing for 302 small blockthere is two small marks on the two timing weels line them up and your good to go
To set the timing on a 1980 Plymouth Horizon, first ensure the engine is at operating temperature and then turn it off. Locate the timing marks on the crankshaft pulley and the timing cover. Use a timing light connected to the number one cylinder spark plug wire and aim it at the timing marks while the engine is running. Adjust the distributor until the timing mark aligns with the specified degree for your engine, which can typically be found in the vehicle's service manual.
The timing marks on your Isuzu 4hf1 engine can be set by looking at the timing marks on the timing belt pulley. The timing belt marks are facing towards the front of the automobile.
The timing marks on your Isuzu 4hf1 engine can be set by looking at the timing marks on the timing belt pulley. The timing belt marks are facing towards the front of the automobile.
Timing marks are on the sprockets and on the timing belt itself. No other marks are necessary.
timing marks are , marks on camshaft sprocket, an on crankshaft sprocket'.
You can set the camshaft timing on your automobile by lining up the timing marks. There will be timing marks on the front main pulley and timing marks on the camshaft.
the timing marks are on the cam and crank gears in the timing case.