0
What else can I help you with?
When does Chevy truck month happen?
Chevy Truck Month starts 9.23 and goes to 10.31
What are the common problems with a Chevy s-10 truck?
Idler Arm on the front end. Starter goes if parked on a hill often. center bearing on the driveshaft
What can happen when a 97 Chevy 1500 wiper module goes bad?
The wipers either act up are just not work at all.
How do you wire up an electric choke on a 1971 Chevy 307 engine?
Not sure about specifically for a 1971 307, but normally the choke has 2 wires. One is ground and the other goes to a fused 12V source (supplies 12V when igition key is turned on)
Could you please tell me the torque specs to replace the idler arm on a 1995 Toyota T100.?
The idler arm shaft, which goes into the bracket should be torqued to 58 ft/lb. The 3 bolts on the bracket to 105 ft/lb. The idler arm to relay rod 40 ft/lb
When was Allan Goes born?
Allan Goes was born on 1971-04-20.
When was Mooch Goes to Hollywood created?
Mooch Goes to Hollywood was created in 1971.
What are the release dates for Lidsville - 1971 A Little Hoodoo Goes a Long Way 1-12?
Lidsville - 1971 A Little Hoodoo Goes a Long Way 1-12 was released on: USA: 1971
What goes backward but never forward?
A reverse idler gear in a manual transmission. It converts the reverse gears turning direction into the outputshaft to reverse its direction. The transmission can not spin clockwise when the reverse idler is engaged thus it only spins backwards not forward.
What nicknames does Chevy Lamont Cofield go by?
Chevy Lamont Cofield goes by Chevrolet, and Chevron.
Will the 1972 Chevy pickup doors fit on a 1973 Chevy pickup?
No a 1972 Chevy pickup is not the same model as a 1973 Chevy pickup. I believe it goes from 1967-1972, 1973-1980, 1981-1987. Doors will work from 1973-1976, 1977-1987. You would need to find 1972 doors as they are the only ones taht will fit a 1972. 1967-1971 are the same but there is something different about 1972 doors.
How do you remove the fan unit on a peugeot 406?
Pin the top tension idler pully..take the front wheel off...the bottom idler pully is on an excentric...loosen same....belt goes slack.... put new belt on,set the excentric as tight as possible.. remove the pin in the top tension idler pully belt should be tight after doing this... happy days
