answersLogoWhite

0

It could be some sort of liquid in the cylinder. It will cause it to hydraulic and bend rods.

User Avatar

Wiki User

15y ago

What else can I help you with?

Related Questions

What are bent engine pistons?

A bent engine piston is a reference to the piston rod. The piston cannot be bent, but the piston rod can be bent.


Can loose rocker cause bent push rod?

Sure can, Quick A bent push rod will cause a loose rocker A loose rocker has no way to bend a push rod, there is no pressure.


Can bad gas cause a push rod to bent?

NO it will not. Over revving engine, Rocker are adjusted to tight, Bad lifter. These are some common causes of that.


What is the shape of the bacteria that causes typhoid fever?

Vibrio cholerae is in a shape of a curved or bent rod. It looks like a fishing rod when you are pulling the caught fish out of the water.


Crankwalk 98 eclipse non turbo 2.0 has a bent crank no other damage- bottom of one piston barely hitting counter weights and same rod has no side play 1-4 pistons not at tdc at exac same time twist?

Bent crank or bent connecting rod. Probably bent connecting rod...


What causes heavy shaking in front suspension?

* Worn components. (shocks, struts, ball joints, tie rod ends) * Out of balance wheel/tire. * Bent wheel


Why a rod immersed partially in a transparent liquid appears to be bent at the surface of the liquid?

When light travels from one medium to another (e.g. from air to a liquid), it changes speed and direction. This causes the light rays to bend or refract at the interface between the two mediums. This change in direction can make the rod appear bent at the surface of the liquid when viewed from outside.


If your 2000 Dodge Grand Caravan 3.3L engine has a bent lifter rod what are your options?

Replace push-rod


How do you fix a bent push rod?

Remove the valve cover. Remove the center nut or bolt that holds down the rocker arm. remove rocker arm, pull out the bent push rod. Install new push rod and put it back together.


How do you tell if you have a bent push rod?

Which ever one you think may be bent, Just take it out and roll it on a flat surface. If it is bent bad you will have a engine miss on that cylinder.


Can carbon steel rods be bent?

It depends on the precise material and the dimensions of the rod


Your steering rack is bent where it joins track rod end what can you do to fix it?

It will have to be replaced. Even bent back to shape with the fatigue would no longer be safe.