0

Subjects>Auto>Automotive Information

What causes low oil pressure in rebuilt 350 Chevy?

Anonymous

∙ 16y ago

Updated: 9/15/2023

Not sure, i would say oil pump or cam bearings

Wiki User

∙ 16y ago

What else can I help you with?

Related Questions

Where do you install the oil pressure gauge on a Chevy 350 small block?

how to install the oil pressure gauge on a Chevy 350 small block

Can a rebuilt Chevy 305 engine with 350 transmission out a 350 oldsmobile's engine?

We do not know what you are asking / question is. Please ask it again with all detailsThanks.

What causes a 350 Chevy to backfire?

It's lean.

What causes 350 chevy to seize?

lack of lubrication

Why would i not get any compression in my motor i just rebuilt It is a 1976 Chevy 350?

It could be the timing chain/sprockets marks are not lined up correctly or the valves are not adjusted correctly.

What causes low oil pressure in 94 Chevy silverado once it is warm 350 motor?

Typical of worn bearings....crank, cam and rod bearings.

How do you set the fuel pressure on a 1997 Chevy 350?

The fuel pressure is not adjustable on that vehicle.

Is it normal for the oil pressure on a Chevy 350 to be 50-60 when cold but go down to 20-30 when hot and 10 at idle if the engine sounds fine and is newly rebuilt and runs well?

I have a 98 with a 350 it doses the same thing NEW ANSWER: It only takes 7 LBS. to compleatly lube a SB. Chevy at an Idle. If you have at least 30 LBS of oil pressure while driving down the road your o'kay

What causes the oil pressure to be 15 psi at idle and 25-30 when driving and the lifters to tick at idle and quit as engine speed is increased on a 1990 Chevy 350 with 50 miles on a rebuilt engine?

Did you replace the oil pump? If not then that would be suspect. Also install an AC/Delco filter before going any farther.

What causes a 1973 350 Chevy to surge with it gets hot?

a vacuum leak.

Why On a 1990 Chevy 350 carter 4 barrel what causes it to back fire or cut out after half throttle and not accelerate- time is correct rebuilt carburetor plugs wires are correct?

Float leval wrong are bad floats. Low fuel pressure, stoped up fuel filter. May not have gotten the carburetor clean enough. IT is running to lean.

What is the oil pressure for a 1999 Chevy Tahoe with a 350?

40-50 lbs

Trending Questions

How far is from San Antonio to Ft Hood? How far is it from auburn AL to Savannah GA? Should you turn off the air conditioner if there are gas fumes in the house? What problem can occur if you have a problem with your distributor cap? What will cause a 2001 suburban 5.3 to start for a few seconds and go dead? What is the top speed of an Olympic Sprinter? What is the distance in miles from Albany NY to Poughkeepsie? What is sales tax on a used car in Texas? What is distance from Las Vegas to Los Angeles? How long will it take to drive 281 miles driving at 82 mph? What damage can herowin do? How long will it take you to drive from Milwaukee Wisconsin to Gatlinburg Tennessee? What side do you put freon in on out unit high or low side? How long would it take to drive 134 miles traveling at 45 miles per hour? How do you find the lock codes for a 2003 mountaineer? Can you junk your car without having the title for it? What is the distance between Miami and Merritt? Where is the turn signal flasher located on a 89oldsmobile 98? How long does it take to drive from Tucson AZ to Detroit MI? When you sell a car should it be smogged?

Resources

Top Categories

Product

Company

Copyright ©2025 Infospace Holdings LLC, A System1 Company. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Answers.