answersLogoWhite

0

Check the resistance on the blower motor.

User Avatar

Wiki User

16y ago

What else can I help you with?

Related Questions

No blower for AC or Heat 96 Escort Wagon. Fuse is good with Power at the Fuse box?

Blower motor located at the passenger side under the dash. Probably the blower motor but you need to check the blower motor resistor and the plug to the resistor. A common cause is the plug tends to melt & short out.


Blower motor works on speed 4 but not on speed 1 or 2 or speed 3?

Need to replace the blower motor resistor which is located just under the passenger side dash. 2 bolts on either side will remove it. Cost of replacement resistor is about $20.


The low speed and second speed blowers doesn't work for the blower motor?

the reason blower does not work on all speeds, is the fan blower motor resistor. The resistor is a 4-5 step series circuit, 1 resistor is added for each reduction in speed. If one burns out then so will all speeds below it. The "high" circuit usually has a separate fuse and bypasses the resistor altogether.


How do you tell if Chevy fan blower resistor is bad or the selector switch?

Examine the back of the switch for loose or melted connections. Then examine the resistor for burned spots. In most cases a burned resistor is the result of a failing blower motor. So if a new resistor burns out in a short time, replace the motor also.


Why won't your blower fan turn off in your 2004 Silverado Everything else works great except it will not shut off and will drain battery?

When the blower motor stays on it means there is a short to power, or the relay is sticking. 99.9% of the time the relay sticks. I belive on the 2004 silverados the blower motor relay is internal to the blower motor resistor. Try to find an auxillary blower motor relay and if there isn't one then replace the blower motor resistor.


What does the blower motor resister do in a 2002 Dodge Durango?

Short of it is the resistor controls the fan speeds for the blower. Easy to replace and to my knowledge only available through a dealer.


Could the blower motor or the blower resistor be bad in my 2003 jeep wrangler there's no air coming out?

Check all the fuses and relays first. If they all appear to be in good working order, then you'll have to get to the blower motor. Could be a short or the motor could be bad.


What causes blower motor to shut off immediately after start up?

A blower motor may shut off immediately after startup due to several potential issues. Common causes include a faulty blower motor resistor, a malfunctioning relay, or a problem with the wiring or connections, which can lead to insufficient power supply. Additionally, a blown fuse or a short circuit in the system can also cause the motor to stop running. It's important to diagnose the specific issue to ensure proper functionality and safety.


What causes the blower fuse to instantly blow in a 99 Chevy blazer?

Short in the circuit somewhere. Try unplugging the blower motor, closing the circuit with a test lead or test light, and seeing if it blows then. If not, the problem would seem to be in the blower motor itself.


Why does the blower motor switch only work on the high speed on my 2004 dodge Dakota?

The most likely cause is a failed blower motor resistor. When they burn out, they leave you with only the high speed fan setting no matter where you set the switch. They're about $20 usually, and can be purchased from any Dodge/Chrysler dealer, and some auto parts stores. It's a super-simple do-it-yourself repair, all you need is a screwdriver. Click through the Related Question below for instructions on how to replace it.


How do you replace the resistor on the blower motor of a 2002 Buick Century The fan works are on higher speeds only Does not work on low speeds?

Buick Century Blower Motor ResistorThe blower motor resistor is located on the back of the blower motor housing under the dash on the passenger side. It can be difficult to get at, but it is doable. Be ready with the ibuprofen the next day for your sore back. Remove the cover panel from beneath the dash on the passenger side.Unplug the power 'ribbon' wires leading to the resitor.Unplug the wires that lead from the resitor to the blower motor housing. There are usually two, one black and one purple that share the same plug.Remove the short hose that leads from the blower motor housing to the ventilation system ducts.Remove the blower motor by removing the three hex screws that hold it in place.Remove the resistor by removing the three hex screws that hold it in place. The resistor is right against the firewall so two of the screws are very difficult to reach. A slender flexible socket extension will make the job easier.Attach the new resistor in place using the same hex screws. Only 1 or 2 of the original three are needed (the part is very light) if you do not feel like fighting with the ones next to the firewall.Reatach the blower motor and reconnect the hose.Plug the power cable wires back into the resitor and the wire from the resistor back into the blower motor.Instead of hex screws mine were held in with 7/32 bolts. It was difficult, but easier than I had anticipated. I replaced two of the three bolts holding the resistor. The blower motor came with instructions saying that the plugs may have to be cut off of the resistor and the blower motor, then spliced together... I had to do this on mine.I got everything back together and now the fan works on four of the five levels. It does not work on high.I found on another site that said "high" uses a different circuit, with a separate fuse. I found the fuse panel on the passenger side of the dash when the door is open. The cover for the panel has all of the fuses mapped out, so it was easy to spot the 25 amp "Blower High Speed" fuse. I was very impressed to find the panel contained a fuse puller and replacement fuses. Mine was blown, I replaced it, and all is good with the world.The information I received here was extremely helpful. Thank you.


Why wont 2007 Nissan Quest blower shut off?

The blower in a 2007 Nissan Quest may not shut off due to a faulty blower motor resistor, a malfunctioning climate control module, or a stuck relay. If the resistor is damaged, it can cause the blower to receive continuous power. Additionally, issues with the vehicle's wiring or a short circuit can also lead to this problem. It's advisable to have a professional diagnose and repair the issue to prevent potential electrical damage.