0
What else can I help you with?
What does a Honda city crank shaft sensor look like?
crank shaft sensor or(ckp) is look like a simple sensor.its color is black.its lenth is two inches.GILL G
You are trying to find the crank shaft positioner sensor?
look at the front (with the pulleys) of th engine
How do you change a crankshaft sensor on a 1993 crown vic v8?
The crank shaft sensor is located on the bottom portion of the timing cover to the left of the crank pulley. Look for two wire harnesses and remove them along with the bolt.
Where is the crank sensor on a 1999 dodge stratus?
The crank shaft sensor is on the bell housing of the trans, buy a new one and look for the plug end that looks alike. also if u are looking for the cam positioning sensor it is on the left side of the engine coming out of the valve cover.
What does the Crank shaft sensor on the Buick LeSabre look like 1995?
Check Autozone.com or another such sight They might have a picture. They did for the same part for my 91 lesabre. (Which may very well be the exact same part)
Location of cam sensor on a 2000 dodge Dakota 4.7l?
Under the front of the right cylinder head. If you look up from underneath you can see the three wire connecter. ************please note that this answer is wrong...this is the location of the CRANK SHAFT SENSOR****************
What could be wrong with your 91 Ford Ranger 23L if it won't start or get spark after you took out the coils and replaced them if all the wires look good?
bad crank shaft position sensor
Where can you find or crank shaft specs?
What you look into what year what type of car you have get a owner's manual and look it up
If your crank sensor goes out how do you know which one to change?
There is only one crank sensor fitted, you may also have a cam sensor. the crank sensor is located either around the bellhousing or around the front crank pulley. It either has 2 or 3 wires. It picks the signal off the revolving crank so look for a sensor in the block near flywheel.
Where is the crank shaft sensor located on a 1998 Chevy Malibu?
I am wondering the same thing; on 2.4l Go to Autozone.com look up your car, and it will tell you if the store closest to you has the part, and give you intructions on how to fix it.
Where is the crank shaft position sensor found 2001 dodge 1500 5.2 liter with standard transmission?
Top pass side of the bell housing. Look behind the pass side cylinder head.
How do you change the crank shaft position sensor in a 2003 Hyundai Santa Fe?
Start by pulling the cover on the bottom of vehicle. remove cover on starter and if you look at an angle towards the driver side up and in you will see the crank sensor. 10mm open end wrench will remove the bolt. trace plug to top driver side.
