0
What else can I help you with?
How do you identify an electric furnace from a gas furnace?
an electric furnace runs off of 208/230 Volts while a typical gas furnace runs off of 120 also a gas furnace will have a valve for the gas relay where the gas enters the furnace.
Can you buy and repace the diaphragm in your furnace gas valve?
No, you should replace the valve.
Where can one find gas furnace prices?
There are many places to find gas furnace prices. One can look on sites like Furnace Price Guides, Century Gas Furnace, and Consumer Reports. One can also find gas furnace prices by going to a local heating supply store.
How is fuel supplied to the pilot assembly on a gas furnace?
In a gas furnace, fuel is supplied to the pilot assembly through a gas line that connects to the gas valve. When the thermostat calls for heat, the gas valve opens, allowing gas to flow to the pilot assembly. The pilot, which is a small flame, ignites the gas, creating a flame that can then light the main burners when the furnace is operating. This process ensures that the furnace operates efficiently and safely.
What is the reason for a furnace to go through all the systems of operations and the ignitor sparks but no gas?
Typically, it is going to be the gas valve. The system sends a 24 volt signal to the gas valve and it opens. I you are getting 24 vols to the gas valve and no gas, it will be the valve.
Why is it necessary to have a pilot safety shutoff on a gas furnace?
so when the pilot goes out the gas valve is shut off
Main burner on furnace burns all the time even with thermostat turned down a no electric signal to valve from thermostst?
Depends on what type of furnace you have but it sounds like 1.a wire from the thermostat is shorted, 2.the thermostat is stuck itself or 3. the main gas valve is stuck. Try turning the power off to the furnace next disconnect the wires leading to the gas valve if this stops it check 1 and two if this doesnt stop it then it is number 3
Why does the home gas furnace blow cold air?
Perhaps the pilot light is out and the gas has been turned off at the valve.
Where can one get information on gas furnace troubleshooting?
One could find information on gas furnace troubleshooting online at Ask. Hvac for beginners is also a great place to look. One could also contact their local gas furnace dealer and/or repairer for gas furnace troubleshooting.
Can you use a gas valve from a 64000 btuh lp furnace into a 124000 btuh ng furnace?
That's less than half the btu's required what do you think!
How can I safely and effectively turn off a gas furnace?
To safely and effectively turn off a gas furnace, locate the main gas shut-off valve near the furnace and turn it to the "off" position. Additionally, turn off the power to the furnace at the breaker box. It is important to follow the manufacturer's instructions and consider contacting a professional if unsure.
How do you know if the thermo coupling on your gas furnace is bad?
The thermocouple tells the gas valve to supply gas to the burners. If the thermocouple is bad then the furnace will not work or the pilot will not stay lit. A properly working one will have a reading of at least 12 milliamps.
